dazjb
24-05-2015, 11:46 AM
Just in the process of wiring in the emanage ultimate for my FTO VR4 conversion and struggling a bit with the airflow wiring. I do not have the VR4 MAF sensor and will be using the Greddy MAP Sensor in its place. I have an IAT sensor tapped into the plenum as well.
Do I need to bother with the airflow wiring on the emanage harness or is plugging in the MAP sensor and selecting it in the software is all thats needed? I understand I then have to enter some info into the software for the 'psi against voltage' table.
Heres a pic of the harness diagram. I'm fine with the rest of the wiring other than the ones with the red dots next to them ...
72501
I'm a bit confused :thinking: .. any help appreciated from you guys who have removed the MAF using an Emanage.
Cheers
Do I need to bother with the airflow wiring on the emanage harness or is plugging in the MAP sensor and selecting it in the software is all thats needed? I understand I then have to enter some info into the software for the 'psi against voltage' table.
Heres a pic of the harness diagram. I'm fine with the rest of the wiring other than the ones with the red dots next to them ...
72501
I'm a bit confused :thinking: .. any help appreciated from you guys who have removed the MAF using an Emanage.
Cheers