View Full Version : Wheel nut torque?
matsondawson
09-05-2005, 05:57 AM
What is the correct torque for wheel nuts on a Legnum VR4?
Physician
09-05-2005, 08:41 AM
What is the correct torque for wheel nuts on a Legnum VR4?
98 Nm
matsondawson
09-05-2005, 10:34 AM
Is that from a manual or a guestimate, and would that be affected by the fact I don't have factory alloys? 235/16/45
Is that from a manual or a guestimate, and would that be affected by the fact I don't have factory alloys? 235/16/45
Anyone confirm 98Nm ?
psbarham
03-10-2005, 06:51 PM
i always use 70 ft/lbs which if i recall is around the 100 nm mark , this setting applys to the stud size so even transits are the same setting
bernmc
04-10-2005, 10:12 AM
Available in our very own club library (http://www.clubvr4.com/forum/showthread.php?t=5507).
Specifically, go to page 31-6 (http://homepage.mac.com/rgdavies2000/.Pictures/Mitsubishi_Manuals/31_Wheel_&_Tyre.pdf), at the bottom...
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.