View Full Version : Airflow mod for intercooler
paulmc
01-07-2005, 09:46 PM
I have raised my number plate and cut away the plastic where the square number plate usually goes. This has freed up a good chunk of intercooler which is now directally in the airflow. 320mm x 65mm. every little helps :thumbsup:
Nick VR4
01-07-2005, 09:52 PM
Looks good
I did um and arr about doing mine
But didnt glad I didnt as the square plate stopped a rock going through the mess and intercooler
I did think about using a chrome mesh too :thumbsup:
SGHOM
01-07-2005, 09:58 PM
I did consider that myself, but the plastic bit is attached to the mesh & i was unsure if the mesh would hold ? /Hmmm looks like it does !!
anyway, I went the route of Co2 spray upwards to cover the intercooler ! :thumbsup:
paulmc
01-07-2005, 10:04 PM
I was thinking of getting a square plate and putting it to the right side of the bumper beside the fog light but it may look like I am trying to copy the evo and I dont want that.
Yeah the mesh was attached but it is pretty strong even with the square bit cut out. as Nick suggested I may got for chrome not sure though.
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.