• Confused


    The VR-4 is a well engineered, high tolerence machine - and running high quailty oils of the correct grade oils, changed on schedule, is imperitive for the health of your car.

    So - here's a list of all the oil types and capacities, as well as recommended oils that our members have found over the years have provided the best protection, and ...

    Here is a simple illustration of the OBD-II port located on the underside of the dash, near the driver's left knee:

    ----------------------------
    \.01.02.03.04.05.06.07.08../
    .\09.10.11.12.13.14.15.16./
    ..------------------------


    Grounding pin 1 is the way to obtain any stored error codes. You can ground it to a chassis point, any other earth, or most usually (because it's closest and easiest) pin 4.

    I use a short piece of wire with stripped ends for the desired effect. A paperclip may also suffice. Some of you may even choose to put in a little switch, so it can be turned on and off as you please!



    This is just one of the many great bits of useful information we have here on Club VR-4. Is this useful to you? Gain access to hundreds more articles by becoming a Member for just £10. See here for more details!


    Instructions:

    1. Earth pin 1, in your chosen fashion;
    2. Turn the ignition on;
    3. You will then have the flashy dash (lights flashing should be Engine Management Light, TCL OFF light (if equipped), 'Skiddy Car' light, 'N' on auto selector (if applicable), AYC light (if equipped), ABS light, SRS light;
    4. Any light that is flashing regularly (about twice a second) has no stored codes;
    5. Any light flashing irregularly, will cycle through all stored codes, repeatedly;
    6. Each code is two digits, and zeroes are not used.
    6a. The values are technically Hexadecimal. In almost every case, only 1-9 are used (i.e. the lowest code possible is 11, and the highest is 99), but some codes use A-F, which will be 10-15 flashes (i.e. 1F is one long flash, and 15 short flashes);
    7. Long flashes (about a second or so each) indicate the first digit, while short flashes indicate the second digit;
    8. There is about two seconds between each stored code;
    9. Codes are shown in ascending numerical order;
    10 Note the codes down, then refer to the diagnostic codes list below.

    To clear the stored codes, simply disconnect the battery (NB: This does not clear SRS fault codes). Sorry folks, ...
  • CVR4 General Search

  • CVR4 - Log in Unregistered

    • If this is your first visit, and you are not registered already, please click the register link below to proceed. Register







  •   Access to the "Members Only" forum.
      Access to the "Resource" Library.
      Access to the "Articles" Library.
      Club discounts .
      First choice to attend future events.
      Access to Members Cars.
      Full Boolean Search Enabled.

    JOIN TODAY
  • CVR4 Event Discussions