Tab Content
Confused's Activity
Visitor Messages
About Me
Friends
My Vehicles
Media
Tab Content
  • Confused's Avatar
    12-04-2021, 07:45 PM
    Confused replied to a thread Forged pistons for 6A13 NA in Performance Mods
    Hello and welcome to ClubVR4. As Davezj has touched on, our MAFs will not work properly in blow-through mode. The way the Karman Vortex generator works requires equal and laminar airflow over it - even changing to a pod filter or replacing the stock airbox messes up the fuelling terribly, and the airflow in blow-through mode will mess with this very delicate and precise metering method. I would also suggest that you do not try to re-use the OEM ECU and a piggyback - yes, you might be able...
    see more
    5 replies | 82 view(s)
  • Confused's Avatar
    09-04-2021, 08:30 PM
    Confused replied to a thread Hello from Hawke's Bay NZ in Newbies Area
    Hello and welcome to ClubVR4! :)
    see more
    5 replies | 75 view(s)
  • Confused's Avatar
    09-04-2021, 08:22 PM
    Confused replied to a thread Newbie to the group in Newbies Area
    Hello and welcome to ClubVR4! :)
    see more
    5 replies | 74 view(s)
  • Confused's Avatar
    09-04-2021, 07:10 PM
    Confused replied to a thread Confused's Long-Term Anglia Project in Random Pictures / Videos / Jokes
    This time round, I investigate what is going on with the clutch, after finding last time that it wasn't quite working right. Will I need to remove the engine *again* to sort it out?
    see more
    311 replies | 9898 view(s)
  • Confused's Avatar
    31-03-2021, 08:20 PM
    Confused replied to a thread Inner TCA's in General / Questions
    Depends on how heavy-handed you are when you take the old one off! (Or, more correctly, how heavy-handed the previous person to do the job was...) I was able to re-use mine.
    see more
    13 replies | 167 view(s)
  • Confused's Avatar
    31-03-2021, 07:54 PM
    Confused replied to a thread Remote Central Locking Solenoid vs Key Locking in Questions
    Nick Mann you are correct, they ground out via the screw. I've found that taking them off, giving them a good squirt with some electrical contact cleaner, and working them manually a few hundred times will get them going for another couple of years!
    see more
    10 replies | 254 view(s)
  • Confused's Avatar
    28-03-2021, 06:41 PM
    Confused replied to a thread MUT II tester vs Evoscan in General / Questions
    EvoScan can use a few different ways to connect - the section in the top left hand corner. If you've not selected the correct combination, it won't connect. If your existing photos had been clearer, and of the whole EvoScan window, I could have already told you if you'd got that wrong! Sent from my Pixel 2 XL using Tapatalk
    see more
    64 replies | 1202 view(s)
  • Confused's Avatar
    28-03-2021, 03:53 PM
    Confused replied to a thread MUT II tester vs Evoscan in General / Questions
    Your photos aren't great - need to see the top left of the EvoScan window to make sure you've got the right connectivity type selected. It looks like it's trying to load a type of hardware that you've not got.
    see more
    64 replies | 1202 view(s)
  • Confused's Avatar
    27-03-2021, 03:46 PM
    Confused replied to a thread Confused's Long-Term Anglia Project in Random Pictures / Videos / Jokes
    In these two episodes, I try (and fail) to get the car outside, but then succeed!
    see more
    311 replies | 9898 view(s)
  • Confused's Avatar
    20-03-2021, 10:05 PM
    Confused replied to a thread MUT II tester vs Evoscan in General / Questions
    The pump pressurises the accumulator. The green lights show how much effort the AYC thinks it is needed to provide. Doesn't in any way show how much affect it actually has. You need to have the car in gear, wheels spinning, applying "power" with the throttle, and turn the steering wheel to get the AYC system to open up the solenoid valves to try to apply pressure to the clutch packs - then the air should start to be pushed out. So it's likely that you did get pressure in the accumulator,...
    see more
    64 replies | 1202 view(s)
  • Confused's Avatar
    20-03-2021, 10:02 PM
    Confused replied to a thread Rubber Washers for Rocker Cover MD327253 - Now Produced By Viamoto in Engine
    That's great! Thanks for investing in making new products for these wonderful cars! I'll definitely check them out when I get round to looking at tidying up my cars!
    see more
    2 replies | 201 view(s)
No More Results

1 Visitor Messages

  1. chugg
    View Conversation
    Got CF mag today. Nice feature mate, well done
Showing Visitor Messages 1 to 1 of 1
About Confused

Basic Information

Date of Birth
May 5, 1984 (36)
About Confused
Membership Number:
714
Location:
Notts
Country:
United Kingdom
Car:
Legnum VR-4
Region:
UK
First Name:
Garry
What letter?:
4

Signature


1997 Legnum VR-4 Type S Project
1967 Ford Anglia 105E 6A13TT Project

Reading fault codes - the "flashy dash" technique

Statistics


Total Posts
Total Posts
3,210
Posts Per Day
0.55
Visitor Messages
Total Messages
1
Most Recent Message
22-04-2013 05:54 PM
General Information
Last Activity
Today 08:23 PM
Join Date
27-04-2005
Referrals
3

1 Friend

  1. vr4drifta 
    Offline

    Registered User

    vr4drifta
Showing Friends 1 to 1 of 1
Add your vehicle to the garage