Tab Content
Confused's Activity
Visitor Messages
About Me
My Vehicles
Tab Content
  • Confused's Avatar
    04-05-2021, 10:34 AM
    Hey Kev! That's brilliant!
    1 replies | 47 view(s)
  • Confused's Avatar
    23-04-2021, 08:03 PM
    In this episode, after the success of getting an MOT test and the car being road legal again, and the sadness of a burnt out coilpack connector and suspected failing engine, I fix the coilpack connector, and begin troubleshooting where that horrible knocking clunky noise is coming from.
    312 replies | 10205 view(s)
  • Confused's Avatar
    20-04-2021, 08:47 AM
    The OEM part number is MR399371 or MN171196. These are the same on LH and RH. There appears to be a compatible item made by Febest, part number 0411EA. I have also heard of people swapping the inner joint from side-to-side, as this puts the worn section in a different place, and you can gain a bit of extra life that way. The OEM part numbers for full driveshafts for your car will be MN156277 (LH) and MN156278 (RH). Can't see a full shaft replacement listed, but again Febest seem to do an...
    3 replies | 75 view(s)
  • Confused's Avatar
    12-04-2021, 07:45 PM
    Hello and welcome to ClubVR4. As Davezj has touched on, our MAFs will not work properly in blow-through mode. The way the Karman Vortex generator works requires equal and laminar airflow over it - even changing to a pod filter or replacing the stock airbox messes up the fuelling terribly, and the airflow in blow-through mode will mess with this very delicate and precise metering method. I would also suggest that you do not try to re-use the OEM ECU and a piggyback - yes, you might be able...
    5 replies | 170 view(s)
  • Confused's Avatar
    09-04-2021, 08:30 PM
    Hello and welcome to ClubVR4! :)
    5 replies | 121 view(s)
  • Confused's Avatar
    09-04-2021, 08:22 PM
    Confused replied to a thread Newbie to the group in Newbies Area
    Hello and welcome to ClubVR4! :)
    5 replies | 115 view(s)
  • Confused's Avatar
    09-04-2021, 07:10 PM
    This time round, I investigate what is going on with the clutch, after finding last time that it wasn't quite working right. Will I need to remove the engine *again* to sort it out?
    312 replies | 10205 view(s)
No More Results

1 Visitor Messages

  1. View Conversation
    Got CF mag today. Nice feature mate, well done
Showing Visitor Messages 1 to 1 of 1
About Confused

Basic Information

Date of Birth
May 5, 1984 (37)
About Confused
Membership Number:
United Kingdom
Legnum VR-4
First Name:
What letter?:



Total Posts
Total Posts
Posts Per Day
Visitor Messages
Total Messages
Most Recent Message
22-04-2013 05:54 PM
General Information
Last Activity
Today 07:03 PM
Join Date

1 Friend

  1. vr4drifta 

    Registered User

Showing Friends 1 to 1 of 1