Tab Content
Davezj's Activity
Visitor Messages
About Me
Friends
My Vehicles
Media
Tab Content
  • Davezj's Avatar
    25-11-2021, 10:23 PM
    Where are you based darren i will all 3 manifolds from you darren. maybe i can collect, but posting is good.
    3 replies | 72 view(s)
  • Davezj's Avatar
    25-11-2021, 10:13 PM
    Davezj replied to a thread Tps short , in General / Questions
    is it idling ok now?
    21 replies | 266 view(s)
  • Davezj's Avatar
    25-11-2021, 10:10 PM
    Hi howardalex alex i am in south manchester.
    12 replies | 89 view(s)
  • Davezj's Avatar
    25-11-2021, 09:56 PM
    it is a pain in the back side to get it out but it will come out. i took mine out a few months ago i ended up taking all the wire harness clips and clamps off the loom to be able to move the look out the way to make it easier to remove the ABS ecu.
    1 replies | 33 view(s)
  • Davezj's Avatar
    19-11-2021, 01:38 PM
    Davezj replied to a thread Tps short , in General / Questions
    Hmmm does not sound good. So you got a known working throttle body from Mo. Fitted this, the TPS started to work, and now it is not working again. Then the immobiliser kicked in and you can't start the car. Is that right?
    21 replies | 266 view(s)
  • Davezj's Avatar
    08-11-2021, 05:43 PM
    Davezj replied to a thread Tps short , in General / Questions
    Which sensor where you adjusting. The TPS on the back of the throttle body or the aps on the front of the throttle body. Least I think it is that way round the one with the idle switch is the 4 wire sensor. It will be good to see if the throttle fixed you issue. It will make you happy to get you far back up and running.
    21 replies | 266 view(s)
  • Davezj's Avatar
    08-11-2021, 01:41 PM
    Davezj replied to a thread Tps short , in General / Questions
    It is still pointing to the tps not being adjusted correctly. Probably not seeing the idle position of the TPS correctly. When the TPS is closed the idle position out should be active. And as soon as you crack the throttle open slightly the idle position out should deactivate. This is what you are setting up with the feeler gauge. As your car is an auto you have an TPS (throttle position sensor) and an APS (accelerator position sensor). Both of which have to be setup correctly.
    21 replies | 266 view(s)
  • Davezj's Avatar
    04-11-2021, 11:35 PM
    Davezj replied to a thread Tps short , in General / Questions
    what difference does it make driving forwards or backwards? the throttle opens the same way and the TPS works in the same way if you are going backward or forwards the only part that makes the car go in a different direction is the Gerabox. are you saying there is something working with the gear box which does not allow it to go forwards.
    21 replies | 266 view(s)
  • Davezj's Avatar
    04-11-2021, 12:08 PM
    i can get arse into gear and put the info up on here this weekend.
    11 replies | 378 view(s)
  • Davezj's Avatar
    04-11-2021, 01:44 AM
    sorry guys i have been very busy at work and home life for the last couple of months it should not be long now and i will have all the info and parts up for sale. i just have not had the time to get everything sorted out.
    11 replies | 378 view(s)
  • Davezj's Avatar
    04-11-2021, 01:27 AM
    Davezj replied to a thread Tps short , in General / Questions
    I might be able to come up at some point to have a look, but i have a sticking rear calliper at the moment so i will have to sort that out first. do you have off road parking or a garage that the car can be put in. this would maximise the opportunity for me to pop up and take a look one evening. depending if the wire break can be found or not, it might be easier to replace the wire from the ecu to the TPS sensor, but that means getting to the back the centre consul area to get to the...
    21 replies | 266 view(s)
  • Davezj's Avatar
    04-11-2021, 12:33 AM
    Davezj replied to a thread Tps short , in General / Questions
    when you testing the wiring are you checking %v to battery ground/chassis gnd or are you check to sensor gnd. if you check to battery gnd and 5 V ok then check to the sensor Gnd and 5v is not at the connector you know there is an issue with the sensor gnd.but if you still get the 5V present then the sensor ground wire should be OK. and it can only be one of the other 2wires. for the next bit you need to know the control type on the TPS sensor. Then back probe the sensor connector wires...
    21 replies | 266 view(s)
  • Davezj's Avatar
    28-10-2021, 05:44 PM
    it sounds really odd.
    0 replies | 63 view(s)
  • Davezj's Avatar
    27-10-2021, 11:47 PM
    some nice tips and tricks on installing a twin plate clutch and a manual gearbox. i will have to check to see if there is lift point on the VR4 gear selector area as i have not noticed one before but hanging the gear box on the chain would be so much easier than lifting the gear box on the jack/lift. i know Nick mann does it with a strap around the gearbox to lift it. but if there was a hook/lift point then this could be usful.
    0 replies | 53 view(s)
No More Results

8 Visitor Messages

  1. View Conversation
    Hi DaveZj,
    I have AYC error codes:
    31, 81and 82.
    I guess that its some wire which is broken.
    Do you have any idea where i can find this wires?
    Best regards
    Morten
    Ps my car is VR4, AUTOMATIC 2.5 1999, 4WD, 280HP SALOON
  2. View Conversation
    Do you know if this set is still the one for the 6a13tt?
    Wanna order 2 sets of them. http://www.energysuspensionparts.com...packagedeal001
  3. View Conversation
    Hi there I have bought a fuel pressure regulator and not sure how to plumb it in really do you have any information please
    Thanks
    Ian.
  4. View Conversation
    Hi there spoke to you before with few issues with my 1996 legnum.well at the moment it running fine touch wood just want to no any contacts that could. Remap mine and hopefully have a newer ecu as mine is 7201, have spoke to Jason about remapping and other ecu to fit but for some reason won't get back to me hope you can help

    Many thanks
    ian
  5. View Conversation
    Pm me your address Dave
  6. View Conversation
    hello mate any luck with postage
  7. View Conversation
    hi Dave can you give my souraund for enyone who go to Guilford RR day please.
  8. View Conversation
    Hey Dave,

    Ecu came the other day, but it wasn't in good condition... it was in awesome condition! Anyway thanks so much for being so generous again. Can you remember if it was from a manual or an auto?

    Thanks
    Josh
Showing Visitor Messages 1 to 8 of 8
About Davezj

Basic Information

Age
47
About Davezj
Membership Number:
255
Location:
Manchester
Interests:
playing with VR-4
Occupation:
Mass Spectrometer/Electronics PCB Design Engineer
Country:
England
Car:
VR-4
Region:
UK
First Name:
Dave

Signature



Bye for Now!

Statistics


Total Posts
Total Posts
16,208
Posts Per Day
2.80
Visitor Messages
Total Messages
8
Most Recent Message
21-05-2020 05:47 PM
General Information
Last Activity
Yesterday 09:13 PM
Join Date
24-01-2006
Referrals
0

7 Friends

  1. CHESHIRECAT 
    Offline


    CHESHIRECAT
  2. dodo_ireland 
    Offline

    Registered User

    dodo_ireland
  3. foxdie 
    Offline


    foxdie
  4. Humpty's Revenge 
    Offline


    Humpty's Revenge
  5. pixelplay 
    Offline

    Registered User

    pixelplay
  6. vr4drifta 
    Offline

    Registered User

    vr4drifta
  7. VR4Kaos 
    Offline


    VR4Kaos
Showing Friends 1 to 7 of 7