Tab Content
Davezj's Activity
Visitor Messages
About Me
Friends
My Vehicles
Media
Tab Content
  • Davezj's Avatar
    16-07-2021, 03:51 PM
    I wish i had the space for it, but just not possible. hat off to for offering it for free to a good home. Top Bloke.
    9 replies | 102 view(s)
  • Davezj's Avatar
    15-07-2021, 12:53 AM
    standard car round town 20-25mpg motorway driving 25-32mpg are you considering creating a VR2 (front wheel drive with VR4 engine) on a 7G platform. it has been doe before. if you are thinking of doing 4wd 7G you will struggle as the 7G chassis does not have the transmission tunnel for the propshaft that goes to the rear of the car to the rear differential. lots of metalwork required.
    2 replies | 61 view(s)
  • Davezj's Avatar
    14-07-2021, 12:00 AM
    Davezj replied to a thread Rear plugs , in Engine
    I am going to release a COP conversion kit soon. it is a completely plug and play kit, no wiring, no metal work making brackets, no looking for screws, washer, spacers, or anything else for that matter. i can even supply the coil packs. watch the forum for updates on this and it will be sold for as cheap as possible to make it affordable for all, to keep these cars on the road.
    14 replies | 172 view(s)
  • Davezj's Avatar
    13-07-2021, 11:47 PM
    thanks for the info Tomasz, i am using the honda coil and that is working great with out dwell modification. i have been running it for a long time, i just wanted to be able to tune the dwell if i even needed to. Is there a possibility the reduction factor table is actually and offset table 100 being 1ms and 96 being 0.96ms, 0 being oms offset. This would account for the 1ms offset when you measure the dwell with a scope and when you look at the requested dwell time. the reason why i...
    7 replies | 510 view(s)
  • Davezj's Avatar
    12-07-2021, 12:34 AM
    Coil Settings 2 = Coil dwell time this is simple it is the required dwell time at a given battery voltage. Coil Settings 3 = Dwell Time Reduction Factor as merlin described it "the third table is the Reduction Factor, reducing the values in this table will result in more Dwell Time at redline". Most COP coil on plug setups can be run with this table set to zero i.e. no Dwell reduction. this means the standard value of 96 means the dwell time will be reduced by 96%, reducing this...
    7 replies | 510 view(s)
  • Davezj's Avatar
    12-07-2021, 12:08 AM
    I have fitted a coil on plug kit which is still used in wasted spark configuration. i understand the description of the first two tables but i dont know what is meant by the description of the 3rd table. This table shown here (the third table in the coil group) <table name="Ignition Coil, Dwell-Time Correction 2" address="122ba" category="Timing" type="2D" scaling="Percent128"> Is just the maximum Dwell percent that will be applied, regardless of any other settings in the other two...
    111 replies | 5704 view(s)
  • Davezj's Avatar
    11-07-2021, 10:39 AM
    Davezj replied to a thread Rear plugs , in Engine
    Probably the best spark plug you can get for spark performance is the cheapest copper only none resistive plug. But these create a lot of noise which is picked up on the radio and potentially in the ECU and other electrical circuits in the car which is why they are not used any more. However standard copper resistive plug are still probably the best spark performing spark plug you can get but they don't last long. If you don't mind changing the plugs every about 5k miles then these are the...
    14 replies | 172 view(s)
  • Davezj's Avatar
    11-07-2021, 10:29 AM
    Davezj replied to a thread Rear plugs , in Engine
    Your plugs look completely buggered particularly if the are all supposed to be iridium tipped plugs. Definitely need new ones. You can get double iridium plugs now with a bit of iridium on both sides of the spark gap. Witch should make them last longer the the standard single centre electrode tip plug.
    14 replies | 172 view(s)
  • Davezj's Avatar
    11-07-2021, 10:26 AM
    Davezj replied to a thread Rear plugs , in Engine
    Coil packs are really expensive about £160 each. And you probably well not be able to find a replacement. You can go second hand replacement but they are all about 20 years old already and if they are working now they they probably done have much life left in them. I am not sure if mitsi still sell original coil packs . I believe the coil pack is unique to the vr4 engine like a lot of other things. And the after market scene do not provide any solutions at present. We are getting a bit...
    14 replies | 172 view(s)
  • Davezj's Avatar
    28-06-2021, 10:12 PM
    hiTim, any luck find the under steering wheel plastic panel?
    38 replies | 820 view(s)
No More Results

8 Visitor Messages

  1. View Conversation
    Hi DaveZj,
    I have AYC error codes:
    31, 81and 82.
    I guess that its some wire which is broken.
    Do you have any idea where i can find this wires?
    Best regards
    Morten
    Ps my car is VR4, AUTOMATIC 2.5 1999, 4WD, 280HP SALOON
  2. View Conversation
    Do you know if this set is still the one for the 6a13tt?
    Wanna order 2 sets of them. http://www.energysuspensionparts.com...packagedeal001
  3. View Conversation
    Hi there I have bought a fuel pressure regulator and not sure how to plumb it in really do you have any information please
    Thanks
    Ian.
  4. View Conversation
    Hi there spoke to you before with few issues with my 1996 legnum.well at the moment it running fine touch wood just want to no any contacts that could. Remap mine and hopefully have a newer ecu as mine is 7201, have spoke to Jason about remapping and other ecu to fit but for some reason won't get back to me hope you can help

    Many thanks
    ian
  5. View Conversation
    Pm me your address Dave
  6. View Conversation
    hello mate any luck with postage
  7. View Conversation
    hi Dave can you give my souraund for enyone who go to Guilford RR day please.
  8. View Conversation
    Hey Dave,

    Ecu came the other day, but it wasn't in good condition... it was in awesome condition! Anyway thanks so much for being so generous again. Can you remember if it was from a manual or an auto?

    Thanks
    Josh
Showing Visitor Messages 1 to 8 of 8
About Davezj

Basic Information

Age
47
About Davezj
Membership Number:
255
Location:
Manchester
Interests:
playing with VR-4
Occupation:
Mass Spectrometer/Electronics PCB Design Engineer
Country:
England
Car:
VR-4
Region:
UK
First Name:
Dave

Signature



Bye for Now!

Statistics


Total Posts
Total Posts
16,106
Posts Per Day
2.84
Visitor Messages
Total Messages
8
Most Recent Message
21-05-2020 05:47 PM
General Information
Last Activity
22-07-2021 11:51 AM
Join Date
24-01-2006
Referrals
0

7 Friends

  1. CHESHIRECAT 
    Offline


    CHESHIRECAT
  2. dodo_ireland 
    Offline

    Registered User

    dodo_ireland
  3. foxdie 
    Offline


    foxdie
  4. Humpty's Revenge 
    Offline


    Humpty's Revenge
  5. pixelplay 
    Offline

    Registered User

    pixelplay
  6. vr4drifta 
    Offline

    Registered User

    vr4drifta
  7. VR4Kaos 
    Offline


    VR4Kaos
Showing Friends 1 to 7 of 7