Tab Content
BraindG's Activity
Visitor Messages
About Me
Friends
My Vehicles
Media
Tab Content
  • Nick Mann's Avatar
    18-01-2022, 11:16 PM
    Not sure which bit the solid bushes are for, but I have skateboard bearings at the gearbox end of my cables. https://www.clubvr4.com/forum/showthread.php?59194-gear-linkage-bushes&p=655173&viewfull=1#post655173 Also by chance I happened to re-read this thread today: https://www.clubvr4.com/forum/showthread.php?63569-Bits-that-will-make-RAOUUL-handle-better&p=701287&viewfull=1#post701287
    3 replies | 73 view(s)
  • Nick Mann's Avatar
    11-01-2022, 09:17 AM
    235/45/17 on a 8" wide with a +35 offset is going to be getting close to the rear arch with the sidewall. Within a few mm. There are always options but if you go wider/lower offset then be prepared to have to solve rubbing issues.
    9 replies | 85 view(s)
  • Nick Mann's Avatar
    11-01-2022, 09:14 AM
    Intercooler, exhaust with down pipes and decat or high flow cat, fuel pump potentially but with a fuel pressure regulator if you do. Tune. That will be enough to take a second off your 0-60 time and make the car feel a lot more lively. Your headline power will not increase by much, but the peak torque and area under the curve increase by a very decent amount.
    17 replies | 158 view(s)
  • Nick Mann's Avatar
    11-01-2022, 08:33 AM
    Yes, but....! The MAF in these cars is a Karman Vortex type, so there is a grid in the air flow that generates vortices which are in turn sensed. For this to work the flow entering the maf needs to be laminar. Many intake systems create their own vortices and if the air entering the MAF has already got a swirl going on then the MAF tends to over-read the air flow and supply too much fuel, causing lower power and worse consumption. Therefore if you change the intake, look VERY carefully at...
    17 replies | 158 view(s)
  • Nick Mann's Avatar
    09-01-2022, 09:43 AM
    Stalling issues can happen with VTA. I run an HKS SSQV and if I dump at high pressure and then keep the clutch pedal pressed the engine will stall. However I can drive around that and the child in me likes the noise!
    17 replies | 158 view(s)
  • Nick Mann's Avatar
    09-01-2022, 09:41 AM
    I know that some items are shared with the eclipse, but as we don't get that in the UK I am not sure I can help too much on the specifics. There is a company on the internet called Amayama that seems like it is set up to source parts from all over and ship them anywhere else. In the UK we use Viamoto - I am not sure if they would ship internationally or not. Hopefully someone will be along to help at some point.
    10 replies | 100 view(s)
  • Nick Mann's Avatar
    06-01-2022, 08:54 PM
    Err.... You will likely need a 90 and a 45, rather than two 90's. I hope that's what you found in the link!
    9 replies | 125 view(s)
  • Nick Mann's Avatar
    05-01-2022, 08:19 AM
    I don't have one, but there are two white versions. One is solid and is on prefacellift cars. One is pearlescent and is on the COTY special edition prefacelift and facelift cars. Just a heads up in case you get the wrong white. Sorry for your bad luck.
    1 replies | 78 view(s)
  • Nick Mann's Avatar
    04-01-2022, 05:19 PM
    The fog lights look like standard facelift items to me. Try googling ganador for the mirrors and seibon for the bonnet.
    5 replies | 122 view(s)
  • Nick Mann's Avatar
    04-01-2022, 05:17 PM
    Nick Mann replied to a thread Head Gasket Replacement in Engine
    Okay, fair enough. It sounds like you could well be right. Hopefully Dave will be along soon to confirm how bad or good my memory is.
    8 replies | 154 view(s)
  • Nick Mann's Avatar
    03-01-2022, 03:43 PM
    Nice name! Evoscan is not reliable with DTCs. Flashy Dash is the only reliable method IMO unless you have access to very expensive Mitsubishi MUT equipment. Your acceleration issue in the mid range, is it like you have lifted completely off and back on to the accelerator pedal? The whole car jerks quite violently. If so, this is likely to be fuel cut, which is either too much boost or a boost leak. In any event it is caused by the MAF seeing more air than it thinks it can supply fuel...
    10 replies | 238 view(s)
  • Nick Mann's Avatar
    03-01-2022, 03:23 PM
    Nick Mann replied to a thread Ozvr4 in General Chat
    Change is inevitable, but glad OZVR4 is back up!
    8 replies | 284 view(s)
  • Nick Mann's Avatar
    03-01-2022, 03:21 PM
    Nick Mann replied to a thread Head Gasket Replacement in Engine
    There are a lot of coolant pipes in the engine bay and a small leak in a pipe will give similar symptoms to a failed head gasket. Most head gasket failures (and there aren't many) are down to running high boost on standard stretch head bolts. Davezj has done this job I think? My memory is that the rear head does come off with the engine in the engine bay but it is awkward at best.
    8 replies | 154 view(s)
  • Nick Mann's Avatar
    03-01-2022, 03:17 PM
    Sorry, I don't know. I'm sure someone will be along at some point who will know though.
    5 replies | 122 view(s)
  • Nick Mann's Avatar
    03-01-2022, 03:15 PM
    Fair play! I hope you continue to enjoy it! :D
    6 replies | 112 view(s)
  • Nick Mann's Avatar
    28-12-2021, 10:02 AM
    Love the Max Power comment! I'm with Tim on the induction comments, but with a slightly different main reason. The MAF is very susceptible to air flow changes so if the flow over the MAF is not linear and uniform then there is a very good chance you will not fuel correctly. Most pod filters will either give more flow in the middle or a slight vortex. This usually leads to over fuelling, so a loss of power plus even worse MPG. Where are you in the UK? If around the midlands there are a...
    21 replies | 476 view(s)
  • Nick Mann's Avatar
    28-12-2021, 09:54 AM
    Nick Mann replied to a thread Must post.......... in General Chat
    Yes, thank you. Hope you did too!
    200 replies | 5881 view(s)
  • Nick Mann's Avatar
    25-12-2021, 06:19 PM
    Cams are way down the list of upgrades. How far are you going?
    21 replies | 476 view(s)
  • Nick Mann's Avatar
    25-12-2021, 06:14 PM
    Welcome back! Enjoy your hunt.
    4 replies | 139 view(s)
  • Nick Mann's Avatar
    25-12-2021, 06:13 PM
    Nick Mann replied to a thread Must post.......... in General Chat
    Looks like you won this year, D. Merry Christmas all!!
    200 replies | 5881 view(s)
  • Nick Mann's Avatar
    23-12-2021, 06:21 PM
    If you have a facelift you may need to change the steel pipe that feeds the intercooler. (The one behind the front foglight.)
    21 replies | 476 view(s)
  • Nick Mann's Avatar
    23-12-2021, 02:18 PM
    Interesting info, I shall have a look!
    49 replies | 1300 view(s)
  • Nick Mann's Avatar
    23-12-2021, 02:17 PM
    I quite frankly don't believe those numbers are comparing apples with apples. The model Y has no parcel shelf, so it seems that they count the whole volume behind the rear seats. It has a sloping rear screen so like pretty much any other hatch/compact SUV there is not enough height for two greyhounds.
    49 replies | 1300 view(s)
  • Atik's Avatar
    22-12-2021, 06:01 PM
    LMAO There isnt anything that will tick those boxes. Hybrids and EVs are pretty much made for the short commutes into crowded city centres, which are increasingly becoming pedestrian zones only.
    49 replies | 1300 view(s)
No More Results

15 Visitor Messages

  1. View Conversation
    Hello braindG
    I've renewed my membership and asked for vr4 pen, I've now lost my old one so was wondering if the new one was on its way.
    Thanks for your time
    Dan
  2. View Conversation
    Hi BraindG still cant pay for tickets, everytime I click checkout the screen just comes back to cart????
  3. View Conversation
    hey man...you know when you get quote notifications? shouldnt there be a way to click and go straight to the thread you quoted in?
  4. View Conversation
    Barry,still waiting for a reply regarding my membership renewal,now had an email warning me it's about to expire,as explained,i did send the £20 by Paypal direct,has it been received,please reply.
  5. View Conversation
    Hi Barry,renewed my membership but the red banner still keeps popping up with a warning that my membership is about to expire,help!!
  6. View Conversation
    Hiya Barry,just to confirm,i have just sent a payment of £20 for my membership renewal thru Paypal,many thanks,Bill Hardy
  7. View Conversation
    Hello Barry. I have just re-joined the site and am trying to post a for sale advert for my VR4, but appear to be struggling. Can you help please? Thanks Mike
  8. View Conversation
    Hi Barry,i am just trying to up date my last post in the for sale section,my daughter has just gone back to uni and i am a caveman when it comes to computers! Regards,Lee.
  9. View Conversation
    Hi,i,ve got problems posting on adds have i got any of my settings wrong?

    shawn
Showing Visitor Messages 1 to 10 of 15
Page 1 of 2 12 LastLast
Page 1 of 2 12 LastLast
About BraindG

Basic Information

Date of Birth
August 12, 1975 (46)
About BraindG
Membership Number:
1
Biography:
After spending many hours looking for information on my beloved car I said, "sod this, im a geek i can do my own site" so I did.. I hope you find this website useful, and informative. Cheers, Barry Elder
Location:
Manchester
Interests:
My VR4, Webdesign, My Mates. oh and Beer.
Occupation:
IT Geek/Nerd/something
Country:
Scotland
Car:
Galant VR4
Region:
UK
First Name:
Barry
What letter?:
4

Signature


SUPPORT CLUBVR-4 TODAY!
Please do not PM Moderators and Committee Directly, for quicker response times please follow this guide
HOW TO: Contact Committee or Moderators

My Articles: Fog Light in Rear Cluster - Changing AYC Switch - Changing Drive Shaft - Changing Front suspension
My Projects: Installing Uprated Clutch - making Gauge Pods (Tri-pod)
Club Related: HOW TO Guides - HOW TO: Contact Committee or Moderators
RIP: Type-S - 1998 R - Trigger Mauve - Mauve History | First VR4 - Second VR4 - Third VR4

Profile for BraindG
Get your own fuel sig in the Garage (Members Only) - Visit my Garage ........What Is Geocaching?

Contact


This Page
https://www.clubvr4.com/forum/member.php?3-BraindG&s=72f18fb20901464358db6b425f3e7ea3
Instant Messaging

Send an Instant Message to BraindG Using...

Statistics


Total Posts
Total Posts
23,219
Posts Per Day
3.38
Albums
Total Albums
3
Total Pictures
34
Visitor Messages
Total Messages
15
Most Recent Message
01-10-2017 04:05 AM
General Information
Last Activity
24-03-2020 03:05 AM
Join Date
05-04-2003
Referrals
2

10 Friends

  1. andyleaves 
    Offline

    Registered User

    andyleaves
  2. Atik 
    Offline

    Registered User

    Atik
  3. foxdie 
    Offline


    foxdie
  4. Kitty's VR4 
    Offline


    Kitty's VR4
  5. New2vr4s 
    Offline

    Registered User

    New2vr4s
  6. Nick Mann 
    Offline


    Nick Mann
  7. Nutter_John 
    Offline


    Nutter_John
  8. richy rich 
    Offline

    Registered User

    richy rich
  9. VR4Kaos 
    Offline


    VR4Kaos
  10. Wobble 
    Offline

    Registered User

    Wobble
Showing Friends 1 to 10 of 10

Click here to browse all media uploaded by BraindG