Tab Content
Tony_T's Activity
About Me
My Vehicles
Tab Content
  • Tony_T's Avatar
    09-05-2022, 02:21 AM
    Zecuel I have a feeling that you are correct but it might be worth a try first since dealers are expensive and MUT's (or MUT software on a PC with the correct adapters) are not that common out in the wild. I wonder if Evoscan can do it? Lots of EVO guys around and other Mitsi folks who use Evoscan.
    8 replies | 85 view(s)
  • Tony_T's Avatar
    08-05-2022, 03:41 AM
    The Snap-on tool is unlikely to speak MUT III language so probably can't clear the fault code. Have you tried disconnecting the battery for a minute or so to reset the controller? I know it's a pain because the transmission and engine controllers forget all the learnt settings for your driving, but it may work, may not. Did the refurbishment damage any connections for the airbag in the steering wheel? Did anything disturb the 'clock spring' that brings the connections to the car's loom? The...
    8 replies | 85 view(s)
  • Tony_T's Avatar
    08-05-2022, 03:27 AM
    Tony_T replied to a thread Stray Connectors in Engine
    OK Cheshire, sorry for the delay, some things been going on here. Confused has posted the above pictures which are really good, I've just had a look at mine and will try to explain in words as I don't have a camera which would be good enough. The two connectors in his upper photo, mounted on a bracket along with another bigger connector, go down under to the ABS unit. The 3 pin inline (right) and the 3 pin triangular connectors (left) at the top of that pic are both on the wiring loom. The...
    7 replies | 145 view(s)
  • Tony_T's Avatar
    30-04-2022, 07:54 AM
    Tony_T replied to a thread Stray Connectors in Engine
    Hey Cheshire, my car has those connectors, I had a quick look but couldn't immediately see what they are associated with. I've been busy but will have a closer look for you when I get some time and some better light in the next few days, if that's any help. Could you post another pic aimed a little lower so I can see the other several connectors which are just beyond the bottom of your pic as I see cut wires on yours and one of mine is connected by a single wire to one of the other bank of...
    7 replies | 145 view(s)
No More Results
About Tony_T

Basic Information

About Tony_T
Radio comms & electronics technician
New Zealand
Legnum VR-4
First Name:
What letter?:


Total Posts
Total Posts
Posts Per Day
General Information
Last Activity
09-05-2022 02:24 AM
Join Date