Tab Content
Yetello's Activity
About Me
My Vehicles
Media
Tab Content
  • Yetello's Avatar
    06-06-2021, 10:02 AM
    Think All 8G (JDM - EUDM) are using the same system. Refrigerant HFC-134A, 670-710 grams If you replaced some parts you might need to add some compressor oil as well with SUN PAG 56 (ammount depending on the part you replaced or cleaned) A good indication of low refrigerant is looking at the sight glass of the filter/dryer if no fluid or foam and bubbles showing in the side glass your refrigerant is low.
    4 replies | 92 view(s)
  • Yetello's Avatar
    04-06-2021, 09:42 AM
    Funny thing is that the body and clips are already prepped from factory to accept the Muffler control system. I can bolt the system right in. No mods needed besides wiring one connector (Vacuum control solenoid) and connect it to some of a control system. Not sure if I need the valve in the exhaust be regulated by RPM or just by a simple switch like alway open if switch is on or always closed if switch is off. If valve is always open it might effect the low rev torque hence I think there must...
    5 replies | 119 view(s)
  • Yetello's Avatar
    01-06-2021, 09:30 AM
    The EC1A had the Exhaust Muffler Control as well so that might be an option to look at. But for all these asian market cars it seems like it is very difficult to get the workshop manuals and wiring diagrams for. The GTO/3000GT also have the option but that's an electrical operated system which has the option to switch the system from Tour to Sport So in the mean time I am waiting for some parts to come in and I already have installed the vacuum line underneath the car. I always was...
    5 replies | 119 view(s)
  • Yetello's Avatar
    27-05-2021, 05:34 PM
    Here is a top tip for you guys that are doing some maintenance on these joints. They need a special grease due to the needle bearings. (inner) Mitsubishi Is only selling the gease as a set with Booth and clamps for almost €100,- per side. If you just want the grease only, Subaru is selling the grease separate for diff side joint (NKG302) Subaru partnumber 28495AE010 (160 grams) for wheel side joint (NTTG2218) partnumber Subaru Part Number: 28395AG030 I paid €17,- for a bottle of...
    4 replies | 235 view(s)
  • Yetello's Avatar
    26-05-2021, 04:27 PM
    Anyone out here that owns or owed a 2.0L V6 EA4A and had the exhaust muffler control working on their car? Maybe someone have, or know where to get, the wiring diagrams for an EA4A. Would anyone know where to find some pictures of the vacuum lines running from the engine bay al the way towards the Left rear towards the Exhaust Muffler Control vacuum box. I do have ASA so I have a schematic of the lines but can't figure out the exact bolt on positions of the lines on the cars body. The...
    5 replies | 119 view(s)
No More Results
About Yetello

Basic Information

About Yetello
Country:
Ireland
Car:
8G Galant
Region:
ROW
First Name:
Ron
What letter?:
4

Statistics


Total Posts
Total Posts
14
Posts Per Day
0.01
General Information
Last Activity
06-06-2021 10:34 AM
Join Date
30-03-2018
Referrals
0
  • No Listings in the database at this time.