In this episode, I start to look at the noise coming from the rear end of the car, and finally start to swap out the differential I didn't fit last year.
My step-dad also pops in to lend a hand.
https://www.youtube.com/watch?v=hGtYbljKzXI
Printable View
In this episode, I start to look at the noise coming from the rear end of the car, and finally start to swap out the differential I didn't fit last year.
My step-dad also pops in to lend a hand.
https://www.youtube.com/watch?v=hGtYbljKzXI
In this episode, I continue fitting up the rear diff, make a stupid oversight that costs me hours of time to correct, and replace the front brakes with shiny new stuff!
https://www.youtube.com/watch?v=SNfdVOwMVSY
In this episode, I finish putting the car back together, and go out to see if the new S14 differential and front brakes have made any difference at all to how the car drives, or if it was all a huge waste of time!
https://www.youtube.com/watch?v=iunJKD8T6PA
looks like it is all coming together.
I've been busy integrating a lot of my dad's old tools and equipment into my home garage, so no progress on the Anglia this time. So, instead, I thought I'd give you a guided tour of the newly rearranged and tidied garage - as you'll probably never see it this clean and organised again!
https://www.youtube.com/watch?v=sc4iePhfYYk
Well garry your garage was lovely and tidy,
/GJ
then we turned and ruined it.
:unbeleeva
the untidy scruffs
:rifle:
but we love you for allow us to mess up your entire garage and back garden.
:iloveyou:
To be fair, it was left in a pretty tidy condition! Only a few dirty rags left on the bench/floor!
Though I've not confirmed that tools haven't been moved around between drawers etc! ;)
I've been talking about it for ages - but in this episode, the Anglia finally makes it onto the dyno!
So - how does it turn out? Did it make decent power? Did it all explode in a big fireball? You'll have to watch the video to find out!
https://www.youtube.com/watch?v=8s33bTGwU68
Hopefully you’ve all seen the last video, where these were flashed up on screen. Thought you’d like to have a closer look at the results of the power run I managed to video.
As I said in the video, this was just a very quick rough fiddle of the power area as I ran out of time on the dyno, nowhere near finished with the tuning – but even with the massive overfuelling, high inlet air temperature and no timing changes, the power figure is still pretty impressive, hopefully a bit more still to be eeked out of it!
https://www.my105e.com/wp-content/up...-vs-Torque.jpg
Calculated Flywheel Torque (dotted line) vs Calculated Flywheel Horsepower
https://www.my105e.com/wp-content/up...heel-Power.jpg
Wheel Horsepower (dotted line) vs Calculated Flywheel Horsepower
https://www.my105e.com/wp-content/up...ost-vs-AFR.jpg
Air-Fuel Ratio (dotted line) vs Boost Pressure
In this episode, I try to do some testing on the chargecooler system, which was shown to be wholly inadequate when on the rolling road, to see where it needs some improvements.
https://www.youtube.com/watch?v=zQxDfvEmkw4
Hi. New here. Here’s the racing Anglia my dad built in about 1984. It’s still going strong and racing the circuits… /Steeringw
Attachment 83203
Here’s a few more…
Hi Andy, lovely to see your dad's old Anglia being used in anger!
After a break to work on my dad's old Shogun (click here to catch up with those videos!), I'm back on the Anglia this time, where I finally make a start on fitting the huge new chargecooler - and of course almost everything about it needs changing!
https://www.youtube.com/watch?v=gqjG3PNynuo
In this episode, I continue work on making the new chargecooler fit - along with the new heat exchanger/radiator, and all the other supporting changes.Sorry for the delay between videos - this took way more work than I expected!
https://www.youtube.com/watch?v=ZwWBFD8pjww