Printable View
Has anybody replaced the studs in the turbo elbow that go through the downpipe?
I've got two turbo elbows now with knackered threads and would like to try and remove the studs and fit new ones if possible. Think hammering in some splined wheel studs would do the trick
Sent from my BLA-L09 using Tapatalk
Yes did it couple weeks back, one snapped, drill them out and fitted new stud ordered from amayama, pita job but can't see any other option, good thing I managed to save old thread in dump pipe.Quote:
Originally Posted by dazjb
Thanks for the reply. I don't mind drilling it out and fitting new studs to make as good elbow
Do you have the part number that you ordered?
Sent from my BLA-L09 using Tapatalk
https://www.amayama.com/en/part/mitsubishi/md014195Quote:
Originally Posted by dazjb
Thanks for that [emoji106]
Sent from my BLA-L09 using Tapatalk
Just got the record, I ended up getting them from Ross Sport...
https://www.rosssport.com/catalogue/...earch=md014195
One unscrewed with heat but the other had to be drilled.. proper twat of a job [emoji35]
Sent from my LYA-L09 using Tapatalk
Fully agree, it's not pleasant, one thing what I learn is to use expensive new, in my case dewalt, drill bits, with them it wasn't as bad as when I attempted this with cheap **** ones.Quote:
Originally Posted by dazjb