9am Wednesday 08/09/05
Thus far, car is in position, tools are ready, and article taped to inside of house window.
wish me luck!
9am Wednesday 08/09/05
Thus far, car is in position, tools are ready, and article taped to inside of house window.
wish me luck!
SUPPORT CLUBVR-4 TODAY!
Please do not PM Moderators and Committee Directly, for quicker response times please follow this guide
HOW TO: Contact Committee or Moderators
My Articles: Fog Light in Rear Cluster - Changing AYC Switch - Changing Drive Shaft - Changing Front suspension
My Projects: Installing Uprated Clutch - making Gauge Pods (Tri-pod)
Club Related: HOW TO Guides - HOW TO: Contact Committee or Moderators
RIP: Type-S - 1998 R - Trigger Mauve - Mauve History | First VR4 - Second VR4 - Third VR4
Get your own fuel sig in the Garage (Members Only) - Visit my Garage ........What Is Geocaching?
Good luck!!
good luck.,.. just not sure what for.
10:40 - quick coffee break
all pipes are off, radiator is out and im about to unbolt the cross member, then the suspension
back at next coffee break
Good luck Barry!! Hope there's not too much
You, my friend, are certifiable. Good luck!
Go Barry................... go Barry !!
bloody hell barry you have got the balls of a elaphant.
hope all goes well.
That's right. Keeping it on the steering wheel where it's meant to be.
hehe.. that wee baby head is our wee Fay.. poor Betty, putting up with dads car bits everywhere...
well done barry.
did you get more power out of car when whouter was your power plant.
is it me, or is it becouse it is a racing clutch on my farther in law scooby (sorry)
it was a bit of a pig to anything gently.
i had Barry and wouter around at mine today to take engine and gear box out again......
to check clutch (ill let Barry tell you the result)
OK today b&w arrived at mine at 8.15
had coffee
8.30 went to garage (helped a truck driver get his truck out of a mess)
9.00 left b&w to do the job (i had to work)
18.00 i finish work back out to garage
10.00 car back on road
10.30 eat dinner at my house and a chat
11.00 b&w on way home
long day but allot done
rich
That doesn't sound too good - what was the problem?Originally Posted by richy rich
Sorry Mate... this is an old thread.... I don't think even Richy will remember this one.
Dated Feb 2006.
This is an old thread, but also the closest I can find to a changing the clutch guide.
Does one exist?
Forgive the sig I'm a guest
http://www.clubvr4.com/forum/showthr...ghlight=clutch
This is probably as close as you will get. IIRC It has all the info you require for getting to the clutch, minus the actual clutch work such as removing the clutch cover, locking the flywheel and undoing the flywheel bolts.
We also know that you should be removing the lay-shaft from the passengers side of the gearbox to make removal / install of the transfer case a breeze (you will require a slide hammer though)
I am surprised there isn't a guide on OzVR4...
If you have any specific questions which you don't feel this guide addresses, just ask.
wow, these were the days
Idd, the PDF on the link that kenneth provided was infact the guide i taped the the windows of my house before i started this job.
i never did write up the full guide, slacker.
I had to lol at the following comment.
Hah, yeah rightOriginally Posted by BraindG