hi my names is mark i have a vr4 owned for 6mth good car but my has been in the garage 4mth no one had tools read the ecu so have just got a new ecu should work i hope. if not were can i get ecu reading kit.thank
hi my names is mark i have a vr4 owned for 6mth good car but my has been in the garage 4mth no one had tools read the ecu so have just got a new ecu should work i hope. if not were can i get ecu reading kit.thank
Last edited by mark wil; 21-11-2010 at 11:28 PM.
evoscan and a laptop , you can also read the codes by shorting pin 1 and 4 on the obd2 port
Tell us your problems dude. We're good listeners and it's good to talk
'97 Legnum VR-4 type S
DONE - SARD 530cc injectors, SARD AFPR, FMIC, MAP2-ECU, Ralliart air filter & 'Special' MAF, Magnecor leads, NGK 7s, Polyeurethane engine mounts, New lash adjusters, RPW downpipes, Powerflow 3" full de-cat exhaust, Reconditioned turbos, Bespoke AYC gauge, SARD R2D2 BOV, CarPC with EvoScan, Fusion amp & InPhase sub, EBC Turbo grooved & dimpled brake discs, EBC red & green pads, HKS SuperForm Lowering springs, Hydraulic bonnet dampers, Momo steering wheel, Bespoke wideband AFR/Oil pressure gauge thingy, New wiper blades all round!, Amsoiled... woo hoo!
Growling out 349ft/lb torque, 296 fly HP @ 0.9 bar
This is a good thread for codes
http://www.clubvr4.com/forum/showthr...agnostic-Codes
& http://reviews.ebay.co.uk/Mitsubishi...00000002365819
Hi & welcome to CVR4.
The mighty Leedsnum has gone but the Airtrek mods will soon fill this space
How To:Contact Committee or Moderators.