Does anyone have the part number for this part?
One site says it's MK-PR800 but I can't find this on Camskill, only the cambelt side one which is MD168055.
Thanks
Does anyone have the part number for this part?
One site says it's MK-PR800 but I can't find this on Camskill, only the cambelt side one which is MD168055.
Thanks
why fix it the right way first time - when excessive swearing can occour when it all goes wrong when you don't?
Now with 5.7 liters of V8 muscle
which end of the crank shaft do you need the sael for, the pulley end or the gearbox end, they are very different seal.
Bye for Now!
Sorry, the gearbox end.
BUMP - does anyone know this as I need to get the order in today to make sure I get it by the weekend.
pnc No. 03080
Mitsi Part No. MD341236 (old red number 359158)
oil seal, crankshaft, RR
rear oil seal crankshaft (1024 x 625).jpg
i think it is this one.
i would be surprised if you get it by the weekend, i would have thought it would be a order in from japan job.
you need ASA database.
Thanks Dave, I found the part at http://www.importcarparts.co.uk and they promise it will be with me tomorrow - better than 14 days as most places were quoting.
Secondly I came across another website that carries the ASA database: http://autopartmaster.com - shows the new code and the pnc number, however not for the VR-4, only the normal Galant. But as we all know alot of the parts are used on both.
Also have some rep
http://www.japancars.ru/cat/mitsubis...x.php?area=M00
Thats the full ASA online version
I got the clutch out for replacing it with a new one.
But I never did change a oil seal.
Can you just pull it out and put a new one back in?
Or do you need to remove the cover the seal is in to change it? (cover shows on the asa image above)
Flywheel off then the seal pulls out and the new one pushes in.