Innovate DB Gauge wiring

[MarkSanne]

After upgrading my VR2 with a large diameter downpipe (like the rest of the exhaust system) I thought now would be a good time to plug in the innovate lc1 / lc-1 wideband lambda sensor kit with a later bought innovate db gauge. I figured out what to wire / connect (I'll use its narrowband simulated output to connect to the factory mitsu ecu.

But... I can't find the wiring harness that came with the gauge. I'm pretty sure it's just a few wires that are needed from the total of 6 wiring pins at the back but I can't find a description or photo of it online.

Anyone on here who has an innovate (db?) gauge and wouldn't mind making a picture of the backside?

[crazydriver81]

http://www.innovatemotorsports.com/s.../DB_manual.pdf

dbconn1.jpg

I think, this is what you looking for?

[MarkSanne]

Almost! I did found the pdf from innovate but this picture helps! Now all I need to know is where the red wire starts when looking at the back the gauge. Left or right?

[crazydriver81]

left to right as viewed from behind: black, white, yellow, red - like the picture is shown.

found on dsmtuners: http://www.dsmtuners.com/forums/newb...wiring-me.html