Results 1 to 17 of 17

Thread: Blow off valve

  1. #1

    Offline
     
    Name
    Andy
    Join Date
    Nov 2021
    Last Online
    04-11-2022
    Posts
    18
    Country
    United Kingdom
    Car
    Vr4 legnum
     

    Blow off valve

    Hi, just thinking of fitting Bov on my motor, where would I get one from,and also is all the induction pipes etc the same as a 3000 gto? Could I go for a bov for one of these? Would it fit? Thanks in advance, I know it's a lot of question's!!!

  2. #2
    TAR's Avatar

    Offline
     
    Name
    Tim
    Join Date
    Apr 2006
    Last Online
    Yesterday
    Membership ID
    346
    Posts
    3,887
    Country
    United Kingdom
    Location
    Aylesbury
    Car
    '97 Legnum
    My Garage
    Visit
     
    As you may know, the VR4 has a recirculation valve fitted as standard. If you fit a BOV it can confuse the ECU a little as it's already accounted for the air you vent to atmosphere. It may cause some poor running. A good aftermarket recirc valve maybe the best way to go.

    I actually use a hybrid valve but have it set on recirc (it was a bargain price when I got it) www.gfbuk.com

    The 3000 GT engine is totally different to the VR4 engine despite the VR4 in the car name so none of the induction pipework will fit.

    '97 Manual Legnum in silver with some subtle mods

    My first VR4 - '97 Legnum Dark Green & mean ...it was love at first sight - now sold

  3. #3

    Offline
     
    Name
    Andy
    Join Date
    Nov 2021
    Last Online
    04-11-2022
    Posts
    18
    Country
    United Kingdom
    Car
    Vr4 legnum
     
    Thanks for the info,no, I didn't know about the recirculation valve set up,I will take a look at the website and see what the prices are like, every days a school day as they say! Cheers!

  4. #4
    Nick Mann's Avatar

    Offline
     
    Name
    Nick
    Join Date
    Sep 2003
    Last Online
    17-03-2024
    Membership ID
    17
    Posts
    24,895
    Country
    United Kingdom
    Location
    Redditch
    Car
    Legnum type-S
    My Garage
    Visit
     
    Evo valves fit.
    I use an atmospheric BOV, an HKS SSQV. This can lead to the car stalling in some circumstances which is for the reasons Tim mentioned above.

  5. #5

    Offline
     
    Name
    Corin
    Join Date
    Nov 2010
    Last Online
    27-05-2022
    Posts
    337
    Country
    United Kingdom
    Car
    Pearly VR4
     
    I also have an atmospheric blow off, Sard R2D2, let's face it we get them for the sound �� you will need to blank off one end of the recirc valve piping, don't ask me how I know but the lid of a 500ml lucozade bottle makes an acceptable blanking plug lol
    They say there is a fine line between hobby and mental illness...

  6. #6

    Offline
     
    Name
    Andy
    Join Date
    Nov 2021
    Last Online
    04-11-2022
    Posts
    18
    Country
    United Kingdom
    Car
    Vr4 legnum
     
    So does your car having running issues with the atmospheric bov? Just getting a little confused on what I need? Cheers

  7. #7

    Offline
     
    Name
    Corin
    Join Date
    Nov 2010
    Last Online
    27-05-2022
    Posts
    337
    Country
    United Kingdom
    Car
    Pearly VR4
     
    No big issues no as I recall but it hasn't run for a few years, the slight dip towards stalling was never a problem.
    The recirc valve can be seen from beneath the car, fitted between the hardpipe from gearbox side of front intercooler, and the plastic hardpipe from front turbo. You remove this, fit your BOV and blank the other side, it's early and I can't remember which side you blank

  8. #8

    Offline
     
    Name
    Alex
    Join Date
    Nov 2021
    Last Online
    05-10-2022
    Posts
    110
    Country
    United Kingdom
    Car
    Galant vr4
     
    I just bought a blitz bov - getting worried about the stalling and poor running having read this, I just want a woosh noise - are you recommending not fitting?

  9. #9
    Nick Mann's Avatar

    Offline
     
    Name
    Nick
    Join Date
    Sep 2003
    Last Online
    17-03-2024
    Membership ID
    17
    Posts
    24,895
    Country
    United Kingdom
    Location
    Redditch
    Car
    Legnum type-S
    My Garage
    Visit
     
    I have a whoosh noise!

    The valve dumping to atmosphere will mean you have a brief period of running rich, as the car will be fuelling for the air it has measured in through the maf, but has exited unmeasured through the BOV. How much that affects you depends on the BOV, the driving style, the tune on your car etc. The only time I notice is if I accelerate hard, then dump the clutch and keep it dumped. The engine stalls then, I'm sure because there is way too much fuel for the air and nothing to keep the engine turning. If I shift into the next gear and come off the clutch then I have no stalling issue.

    Fit it and give it a try - worst case scenario you'll swap it back again!

  10. #10

    Offline
     
    Name
    Alex
    Join Date
    Nov 2021
    Last Online
    05-10-2022
    Posts
    110
    Country
    United Kingdom
    Car
    Galant vr4
     
    Quote Originally Posted by Nick Mann View Post
    I have a whoosh noise!

    The valve dumping to atmosphere will mean you have a brief period of running rich, as the car will be fuelling for the air it has measured in through the maf, but has exited unmeasured through the BOV. How much that affects you depends on the BOV, the driving style, the tune on your car etc. The only time I notice is if I accelerate hard, then dump the clutch and keep it dumped. The engine stalls then, I'm sure because there is way too much fuel for the air and nothing to keep the engine turning. If I shift into the next gear and come off the clutch then I have no stalling issue.

    Fit it and give it a try - worst case scenario you'll swap it back again!

    Thanks Nick! I'll ask them to put the original part in my boot and keep it in case! Hopefully there won't be any stalling issue will be ok as it's an automatic so i guess no clutch lifting after it dumps!

  11. #11
    Nick Mann's Avatar

    Offline
     
    Name
    Nick
    Join Date
    Sep 2003
    Last Online
    17-03-2024
    Membership ID
    17
    Posts
    24,895
    Country
    United Kingdom
    Location
    Redditch
    Car
    Legnum type-S
    My Garage
    Visit
     
    It can happen if you lift off and brake hard coming to a stop in auto too. Some people have a lot of problems and some don't - hence I suspect it is a combination of quality of the valve, other boost leaks on the car, the tune on the ecu, the driver themselves etc... My car is relatively subtle to look at even though it is well modified. The exhaust tip and the dump valve are my two "immature" modifications!

  12. #12

    Offline
     
    Name
    Andy
    Join Date
    Nov 2021
    Last Online
    04-11-2022
    Posts
    18
    Country
    United Kingdom
    Car
    Vr4 legnum
     
    So,I contacted a company about bov's, and they are recommending I need x2 because its a twin turbo, is this correct as I think not? Cheers

  13. #13
    TAR's Avatar

    Offline
     
    Name
    Tim
    Join Date
    Apr 2006
    Last Online
    Yesterday
    Membership ID
    346
    Posts
    3,887
    Country
    United Kingdom
    Location
    Aylesbury
    Car
    '97 Legnum
    My Garage
    Visit
     
    That's not correct. The car only requires one.

  14. #14

    Offline
     
    Name
    Alex
    Join Date
    Nov 2021
    Last Online
    05-10-2022
    Posts
    110
    Country
    United Kingdom
    Car
    Galant vr4
     
    I just bought the one as TAR said! Only thing I would say is..... have a look on this forum before you buy one. I paid over £200 for mine from blitz and 2 days later I saw a BOV advertised on here for £65

  15. #15
    Confused's Avatar

    Offline
     
    Name
    Garry
    Join Date
    Apr 2005
    Last Online
    Today
    Membership ID
    714
    Posts
    3,536
    Country
    United Kingdom
    Location
    Notts
    Car
    Legnum VR-4
    My Garage
    Visit
     
    Quote Originally Posted by Andygarnett View Post
    So,I contacted a company about bov's, and they are recommending I need x2 because its a twin turbo, is this correct as I think not? Cheers
    Yet again, companies getting things totally wrong because they don't know the cars!

    As everyone else has said, only a single one needed, and ideally recirculating. Though there are hybrid ones, where you can choose how much to recirculate and how much to vent, so if you want a bit of noise, you can have it without upsetting the running of the car too much!

  16. #16

    Offline
     
    Name
    Mike
    Join Date
    Feb 2022
    Last Online
    01-01-2024
    Posts
    24
    Country
    United States
    Location
    Chicago
    Car
    97 Legnum VR4
     
    Do you remember what model GFB Hybrid Valve you went with? I was originally looking at the T9033 but after reading your comment I am now looking at this list https://gfb.com.au/products/blow-off...id-2018-02-19/

  17. #17
    TAR's Avatar

    Offline
     
    Name
    Tim
    Join Date
    Apr 2006
    Last Online
    Yesterday
    Membership ID
    346
    Posts
    3,887
    Country
    United Kingdom
    Location
    Aylesbury
    Car
    '97 Legnum
    My Garage
    Visit
     
    GFB 1012RE but I think it's an old model no longer available.

    Looks a bit like this one https://gfb.com.au/products/blow-off...-valve-detail/


Similar Threads

  1. FS : Sard R2D2 blow of valve/dump valve
    By Humpty's Revenge in forum UK Parts for Sale / Wanted
    Replies: 12
    Last Post: 01-09-2015, 08:40 AM
  2. blow off valve
    By curtisadam in forum General / Questions
    Replies: 7
    Last Post: 04-01-2014, 12:02 AM
  3. FS: HKS Blow off Valve
    By Louis in forum UK Parts for Sale / Wanted
    Replies: 3
    Last Post: 03-11-2008, 10:30 PM
  4. Blow off valve
    By marmel31 in forum General / Questions
    Replies: 2
    Last Post: 30-03-2006, 09:45 PM
  5. Blow off Valve
    By zentac in forum General / Questions
    Replies: 13
    Last Post: 30-06-2003, 06:51 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •