OK i need to change tc seal on my car.
if i can get the seal before next weekend I'm going to have a go my self.
is there any body out there that wants to have a go at it with me.
i will also need some tools if i cant scrounge them ill have to buy the
i will also try and do a write up on it so others can have a go at it as
it seems to be a common problem.
tool list
1 socket set(yes) must be a good one and a long bar
2 axle stands(yes)3 is best. two for car 1 for prop shaft
3 Jack(yes)one that will lift high the 1.5 tone one i bought would have done but wouters 3t was better
4 screw drivers(yes)
5 spanners(yes)mainly 14, 17, 19, and u will need a 7/8
6 ball joint splitter(yes)don't need
7 pry bar(yes if bern comes up)two decent ones is best but used 2 crow bars it done the job.
8 engine lifter or some thing to hold engine up.(maybe rope over joust in lockup)
9 transmission jack or some thing to hold trans in place pos axle stand.(pos)jack used for this and when of jack it went on to my car creeper
10 torque wrench(yes)
there will be tea food and beer if any body wants to stop over for sat night (only couple of spare beds thou.)
t.c seal number MD707575