On trademe : Cheap coil overs

[Gly]

not me selling...
just incase someone wants them.

http://www.trademe.co.nz/Trade-Me-Mo...n-56214600.htm

[mpau009]

Thats the same as the ones i had on the STR, got them for $280, theyre pretty stiff, but handle well enough, i might have a look if they stay fairly cheap

[Kenneth]

Look to be the same model as in my car... and mine handle very very well

[ShadyNZer]

what tools do you need to adjust the suspension? sucks taking it to hyper tyres all the time lol

[Kenneth]

what tools do you need to adjust the suspension? sucks taking it to hyper tyres all the time lol

I have the C spanners that you need to spin the spring perch.

[ShadyNZer]

are they expensive? where bouts do u get them from?

[You See]

You can find them on TradeMe (none at the mo tho) for around $20-40...Hyper tyres also sell them for around $40ish too.

[SNWMAD]

I just picked up some bilstein adjustables for $450 today, their just under a year old. i Think that was a pretty good deal!

[mpau009]

You can find them on TradeMe (none at the mo tho) for around $20-40...Hyper tyres also sell them for around $40ish too.

If a few people want them, then i could get them made up, for my last set i got a mate doing design to draw them up on an engineering program, and had them water cut, for two sets it was about $30? Anyone with the software can do it in about 10 minutes. You just have to wait a while (about a week) until they can fit in your small cutting job.

[ShadyNZer]

pretty hard to adjust the suspension up and down?? whats involved? if not too much involved then id be keen on some

[Gly]

i bought mine of TM for $40, UCs got them atm...

not alot involved, jack up the car, loosen the locking nut, and wind the upper nut up or down to suit.

[You See]

UCs got them atm...

Got what? ..dum de doo
...all this talking has reminded me that I need drop mine a lil' this weekend...what do you reckon, drop by an inch?

[mpau009]

Got what? ..dum de doo
...all this talking has reminded me that I need drop mine a lil' this weekend...what do you reckon, drop by an inch?

Bottom them out, and work your way up, for certing the lowest structural point is the bottom of the front suspension arm-a-majig, if you get it certed they record the measurements, so you might as well have them as low as possible. But yeah for around town, an inch/inch and a half would look good.

[Gly]

only at $72, finishes tomorrow at 1pm.

anyone gonna have a bid??

[pezza]

Hmmm I would but am in the wrong country

Don't think anyone outside NZ can register on trademe?

[You See]

Hard luck mpau....oh well, there's always them Teins!

[Gly]

dam they went cheap, a little over $150,

cant even get lowering springs for that kinda $$
someone got themselves a deal

[ShadyNZer]

thats like some cheese got a hid kit for a hundy...was a H7 one i didnt know what type to get so i didnt bid, so as i was doin a search on here trying to find out if the H7 was alright the auction closed..lol gutted man!!!!

[Gly]

LOL, i gotmy hid kit for $50, hehe