recirc valve

[gaz70]

i have a hks blow off valve,but the muppet that put it on did not take off the old re circ valve. I was told that i just kneeded to bung up the 3 tubes after taking it off. I have done this and bunged it up with some wood and jubilee clips. My question is is this the right thing/or way to do it, and is there any tempreture concerns with it being wood.I am not using the car just yet until i know it is safe.

[Wodjno]

i have a hks blow off valve,but the muppet that put it on did not take off the old re circ valve. I was told that i just kneeded to bung up the 3 tubes after taking it off. I have done this and bunged it up with some wood and jubilee clips. My question is is this the right thing/or way to do it, and is there any tempreture concerns with it being wood.I am not using the car just yet until i know it is safe.

If you have bunged up the wholes where the old recirc went !! Where is the HKS 1 fitted ??

[gaz70]

it is fitted on the large pipe just to the right of the engine between the air filter.

[gaz70]

I think i will fit it were the old re circ was, might get some bettor noise

[Axeboy]

It should just replace it yes...

The larger pipe returning towards the dash of the car is the only one to be blocked off here...