Not any more it's notOriginally Posted by White Lightning
J
(Wayne, I think he may have measured the gap prior to fitting - I'll give him a nudge tonight )
Not any more it's notOriginally Posted by White Lightning
J
(Wayne, I think he may have measured the gap prior to fitting - I'll give him a nudge tonight )
The car looks great....not as low as before but its a good height. I think the gap was about 35mm before at the front and its now about 45mm+/- The Teins are the same set up as on may car. The springs that came off were thick and possibley Cusco...looked an expensive set up with differing rate springs top and bottom. The Teins are about half the thickness. We can lower HJM's a bit but i think its ok
It'll do me...............
Sounds interesting...
I have the same setup but not put on the car as yet.
Assuming its the same spring rate does the car feel like it has enough travel to bottom out when the car has 4 adults in for example or high speed lil dips in the road?
45mm sounds about right to me too. Whats it like on the back?
Cheers
It's not taxed yet, but I'll let you know after lunchOriginally Posted by pezza
J
(Seriously though, it won't get four adults in it until next week, so we will report back then - it's good to have it back though )
Don't worry Wayne, your Tein will come preset to a nice ride height, it'll drop the car a bit.Originally Posted by White Lightning
I had to raise the back a bit as I still have the little standard wheels...
"With sufficient thrust, pigs fly just fine. However, this is not necessarily a good idea. It is hard to be sure where they are going to land, and it could be dangerous sitting under them as they fly overhead."