It Doesnt Fit

[StunEm]

This one is for all the members that have converted there auto to a manual.

The gearbox parts finally arrived for mine, everything going to plan until i tried fitting the flywheel. The original auto plate mounting onto the crank is about 44mm in diameter, my flywheel inner diameter is 40.5mm.

Is there a spacer ring fitted on there that comes off or do i have to get the flywheel inner hole machined out to fit.

[BraindG]

Not done a conversion, however this thread might have some usefull pics?

[d i c k i e s]

ask bradc! hes converted his to a manual.

[bradc]

I didn't do the work on my car though, someone else did it all. They didn't tell me about any issues like that though

[StunEm]

I found the answer out today.

Talked to the suppliers of the gearbox and they mistakenly sent down what looks to be a evo 7 (maybe) flywheel.

They sent today a new flexi plate (centre of the flywheel, since these ones are a two piece flywheel) One thing i did notice was that the flywheel was just machined and Balanced before i got it. Good Stuff Kempy's.
Should arrive tomorrow morning and i can bolt it all together and put the gearbox in tomorrow night. If i work fast, i should be driving the car later that night.