Hey guys,

glad this has been taken seriously.

I took the front end apart this evening and to my astonishment the damage is not that great. The lower arm obviously failed, the curved arm rubber bush has been ripped apart and i think the upper wishbone arm has been bent at the ball joint.

bodywork wise .. managed to push the wing back into shape by hand (thin panels are good for something) and the inner plastic wheel arch should go back into shape with a heat gun..

luckly i have a new driveshaft already as i was going to replace it after i bought new lower arms... only i did'nt intend on removing the old drive shaft quite in that manner...

I intend on posting photos of the bits when i charge my camera.

Dan