wobble/vibration since lowering

[ANTHONY]

since fitting shocks and spring which as you can see from the other post., it's quite low. I'm now getting wobble/vibration but only when i 1st pull away.once i get going its ok.
a few of you said tram lining last nite I will need the tracking done.
is this the only problem it could be and will it be ok to drive until next weekend when i can get it done. apart from shagging the tyres

[Nutter_John]

when you lower a car the goemtery goes all over the place , your camber will be out , your toe will be out ,

Given that I am driving with -1.5 <-> -2.59 camber and it only drives straight if i hold the wheel then i would say it should be fine , but yeah you will start to fook you tryes if you keep it that way .

Also don't forget when you do the alignment make sure it is a full on 4wd one

[ANTHONY]

so will that be the cause of the wobble at low speed?

[Nutter_John]

Would have thought not a wobble , describe it more

Oh you did tighten the wheel nuts up didn't ya

[ANTHONY]

more like a judder/vibration