Where do you guys go to get parts like the cam belt, idler pulley, tensioner pulley, and auto tensioner?
Where do you guys go to get parts like the cam belt, idler pulley, tensioner pulley, and auto tensioner?
Mitsi would be your best bet.
I have priced it up against Recpo etc and is very similar priced.... Our guys down here will sell an aftermarket part(usually the same as from repco, and usually cheaper) if the genuine is expensive...
J
Hmm, I've always had the impression that the local Mitsi dealer here in Christchurch (Donnithorne Smith) is expensive. I guess I should go have a look then rather than rely on rumour.
BNT have always helped me out
You mean Donnithorne Simms
I used to work there, my old man still does.
And yes they are relatively expensive, they have their own mark ups on parts they get from places like BNT.
Let me know what you need, I might be able to get some parts a lil cheaper
1994 Galant VR-4, 6A13TT conversion 230kw atw
2000 Legnum VR-4, Daily driver
1995 FTO GPX
At this stage its looking like cambelt, tensioner pulley, auto tensioner, and idler pulley.
Geez.... .what ya do snap the cambelt or something lol
I think it was too tight, so it run a bearing (not sure which one yet) and slipped a tooth on one of the heads, so its not running smooth at all, and there's a high pitch whistle coming from the bearing.
The water pump is also leaking again and I think I need to flush the radiator out after the blown gaskets from last time. Joy!
I did the water pump just recently, but stupidly (I think) didn't do the timing belt etc at the same time, as the dealer told me they'd done them just before I bought the car (it was one of the conditions of sale). I'm pretty sure they did a half assed effort if at all.