Replacing wheel stud ?

[kiteman]

I need to fit longer wheel studs.
The fronts seem to be straight forward enough.

Has anyone on here tried tackling the rear ones ?

From what I can make out, the rear halfshaft will need to be pulled out of place by about 2 inchs to get the old studs out and the newer longer ones in.

I've tried the search function, honest.

[kiteman]

Bump

[kiteman]

Bump again, come on guys please, somebody must of tried this before

[Subaru ETA]

have you tried to get them out? some cars you do have to take the shafts out, some you dont.

Dissasembe the handbrake shoes and knock a stud out - then you will see if you have to take the shaft out.

i havent done them on mitsi's but i have had to change a few.

EDIT: if you are fitting longer studs id say you would have to move the axle aout a bit to get the new ones in