Leather Interior

[philm77]

Hi Anyone Interested In A Full Cream/tan Leather If So Check Out Ebay Item Number 250691939006
If Interested Pm Me Or Message Me Through Ebay!!!
Take A Look!!!!

[aboo]

link for you http://cgi.ebay.co.uk/ws/eBayISAPI.d...fvi%3D1&_rdc=1

Would'nt mined the door cards of you.

[jahooli]

Im after a set but i need the estate.

[philm77]

Thanks For The Link Cheers

[aboo]

Im after a set but i need the estate.

They are for an estate but not sure if they are electric & heated?

[jahooli]

the ad says saloon, do they fit the leggy?

[ianturbo]

the ad says saloon, do they fit the leggy?

fronts do rears don't !
ian

[aboo]

If you look at the pics the back seats are split. I know there out of a saloon but they may be out a V6 estate cause the saloon never had split seats in the back.

[jahooli]

Good eye balls, so the split seats fit the leggy?

[aboo]

[aboo]

But as I said unless we see pics of the side of the front seats dont know if there electric & heated.

[jahooli]

says so in the ad, not bothered about that, wouldnt know how to wire them up. ive been after the tan leather since before i bought the leggy!

[aboo]

Sorry Never read that far into it. I saw PT do the electrics on mine & it did'nt take him long & there is a article on here that Atik put up that tells you how to wire up the heated side of things

[jahooli]

ok, confirmed by philm that they came out of a saloon, can anyone tell me if they will fit the legnum?

thanks

[philm77]

Hi Everyone Whos Asking About This Leather:
Yes Full Electric Adjustable
Yes Heated
Yes Split Seats In Rear
Still Have Complete Car So All Switches Plugs Wire Etc Could Be Removed When Seats Were Collected
Hope This Helps
Cheers Phil

[Atik]

The saloon fronts will go in fine, and if you are worried about wiring them for electric and heating, I have a good guide on that.

The saloon rear seats wont go into an estate as the side bolsters are different. Note that the UK saloons DID have slit fold rear seats in the saloon. And they will fit into any other saloon, however, the JDM saloons (that dont have split fold rear seats) do not have the anchor points to hold the seats in place. Jason's car had this transplant from a UK saloon to his JDM saloon VR4 and Nick Mann had to drill out the spot welds that held the anchor points and then re-weld them into Jason's car. Worked perfectly but requires some work!

[jahooli]

somebody sell me some levver that fits!!

[SGHOM]

Levver is too slippy when cornering hard !

[Wobble]

Levver is too slippy when cornering hard !

yeah but wipes clean easyier when you get to exited

[Humpty's Revenge]

Levver is too slippy when cornering hard !

Don`t with me

I wish I did slide when cornering but 21+ stone acts like an anchor YEP THAT`S ANCHOR and my butt goes nowhere