re-mapping

[brettkel]

Thinking of getting my car re-mapped. Where is best place to go and which is the best way to do it, i want more torque and more horsepower.

also been looking at an induction kit a blitz one - wanting one with a nice deep sound any ideas.

[bradc]

Don't get a pod filter, they are crap.

Now for the tune, you need to do a search for 7201, 7202 and 7203 and figure things out for yourself. It is a bit complicated and a normal reflash place won't be able to handle it.

[brettkel]

how do i found out 7201, 7202 and 7203 i have a 2000 model facelift

[elnevio]

Yours is probably a 7202, although the only real way to be sure is to take out the ECU and look in the case.

[Nutter_John]

Yeah if it is a plastic case then it is either a 7202 or 7203 ecu

[swinks]

My bet is on 7203...

[kinkyafro]

Easiest way is to check take off the little plastic panel in the footwell by your left foot (1 screw).

Then note the casing type and the 4 digit number on the side of the ecu.

Metal case = 7201 ecu
Plastic case 0288/0289 4 digit code = 7202
Plastic case plus any other code = 7203

but as stated above only way to be sure is take the ecu out and look inside.

[Nutter_John]

Yeah agree rich esp after that 7203 found in a PFL

[bradc]

The 7203 wouldn't have been it's original ECU though.

Being a 2000 car you should have a 7203 ecu

[brettkel]

thanks for that will have a look and let u know

[Shtiv]

Move to australia and I'll tune it for you....

I'm guessing a 7203.... Either way, an 03 or 02 is flashable

[Nutter_John]

Move to australia and I'll tune it for you....

Of course good idea as no one from the UK could do that for him

[Shtiv]

well no one else suggested they would....

And it works for me....

[Adam.Findlay]

dont forget 7203's also come in metal cases, I have one, i can also send you my tuned rom if you have the stones to be fiddling with your ecu yourselfif not id leave it to a tuning shop

[Nutter_John]

dont forget 7203's also come in metal cases, I have one, i can also send you my tuned rom if you have the stones to be fiddling with your ecu yourselfif not id leave it to a tuning shop

can you post up some photos of that Adam as the design of the boards for 7203's are not the same as 7201s so the cases are not swapable

[Adam.Findlay]

ive nevr taken it out, im pretty sure its metal from when i chopped my speed cut wire, Although i have now tuned it out properly. if i get the time tomorow i may do it for your intrest

[Shtiv]

All the 7203's I have seen were plastic cased and for pics, see here....

http://ozvr4.com/forums/showthread.p...ch-do-you-have

[scott.mohekey]

There's a metal cased SRS ecu sitting above the engine ecu that may have confused you adam.

Edit: the SRS ecu is below the engine ecu.