Wellington Dyno Chat Thread

[CANDEE]

Could be keen but depends on funds when's cut off data for the rsvp?

Payment cut off will be the end of Jan. so you have 2 months to sort the funds out..

[kNuTz]

Unfortunately we have received an invite to a wedding on the same day.
So looks like you will have to remove me from the list and I'll have to organize a solo run at some point as I don't know how long the group session will take on the 26th.

[RXWPN]

Im keen for another power run to see if all is still working as it should.

[CANDEE]

Unfortunately we have received an invite to a wedding on the same day.
So looks like you will have to remove me from the list and I'll have to organize a solo run at some point as I don't know how long the group session will take on the 26th.

If you have to be in and out early, we can always put you on as the first runner?? I think it usually takes about 30-45 mins per car for putting the car on the dyno, setting it up(if the car hasnt been on speedtech's dyno) and the doing two power runs. So prob be about a 3pmish ending to the day..

Let me know how you feel about it.

[CANDEE]

Im keen for another power run to see if all is still working as it should.

Excellent Justin, ill add you to the list. What variety of VR4 do you have??

[CANDEE]

Also we are almost full guys. 10 is the magic number due to the time it takes to get the cars on and off... lol I know it taked Andre an hour to do the same all by himself normally..

[kNuTz]

If you have to be in and out early, we can always put you on as the first runner?? I think it usually takes about 30-45 mins per car for putting the car on the dyno, setting it up(if the car hasnt been on speedtech's dyno) and the doing two power runs. So prob be about a 3pmish ending to the day..

Let me know how you feel about it.

That would be perfect if that could be set up, I could of course stay a little longer to catch up with the guys but be able to disappear when required.

[CANDEE]

That would be perfect if that could be set up, I could of course stay a little longer to catch up with the guys but be able to disappear when required.

Should be able to arrange that for ya matey. will note it in the other thread so I dont forget.. lol

[kNuTz]

Should be able to arrange that for ya matey. will note it in the other thread so I dont forget.. lol

Cool, may be a newb question but for funds reasoning, what does doing the +$10 for AFR get?
I have a AFR gauge which should be installed well before this dyno day.

[CANDEE]

Cool, may be a newb question but for funds reasoning, what does doing the +$10 for AFR get?
I have a AFR gauge which should be installed well before this dyno day.

The AFR is a wideband which is referenced vs the rpm as the one below:

DynoRun-AFR.jpg

This will be able to accurately, where a problem is located, if you do have one, also it tells you how rich the car is running and how fast it gets there... lol

What you most likely have is a narrowband, which is taken off the car's o2 sensor, which is basically a visual guide and nowhere near as accurate as a wideband.

[Kenneth]

In other words, it is well worth the $10. In fact, I would go as far as saying that there is no point in spending the money to do a dyno run and NOT not spending the extra to have the Air Fuel Ratio measured.

[kNuTz]

Sweet as, will go for the lot then

[popin]

Count me in if there's still room

Keen for AFR as well

[CANDEE]

Count me in if there's still room

Keen for AFR as well

You are on the list Simon.

I have also added the other half's car, specifically for when project d-ninja race car goes ahead...

[CANDEE]

Ok gents we are slowly getting closer.

Hopefully everyone is getting their cars all ready.

Just went and visited Speedtech today and stocked up on some nice Motul Turbolite 4100 oil goodness for the car.

PM me for account details and I am happy for you to drip feed the $$ in till you are paid up.

J

[popin]

Actually pop me out of the list sorry

[CANDEE]

Actually pop me out of the list sorry

Why is that Simon? Hopefully not something serious?

[popin]

Basically I'm dirt poor/need to pay some debts/christmas/newyears/summerholiday/moving out start of next year... and need the cash...that combination doesn't mix well with a twin turbo v6...

The VR4 has to go

[low_vr4]

Basically I'm dirt poor/need to pay some debts/christmas/newyears/summerholiday/moving out start of next year... and need the cash...that combination doesn't mix well with a twin turbo v6...

The VR4 has to go

just seen it on trademe, good luck

[CANDEE]

Ok Guys,

We are steadily closing on the month out mark.

Are we able to get confirmations via payment? I am happy to accept the cost being paid off in parts if need be.

J