Project Panda

[Dmooney]

I hope this is the right forum

Original Pics of the Car




Turbo Kit


Stripped the head's right back

Big service with new, Head gaskets, water pump, oil pump, timing belt, iridium plugs, magnicor leads.

Fit new vernier camgears


350cc injectors.


Bottom end work,
New big end bearings, main bearing, oil seal's, PAR forged conrods CP 8:5:1 compression, ARP headstuds,



Now some stoppers.
Alcon 6 POT callipers



330 mm disks




VF28 turbo wasnt quite good enough so picked up a VF35 turbo from a type RA scooby WRX


D2 coilovers & topmounts Fitted, LSD & 3 PUCK paddle clutch.
getting the power down with some new rubber


Car stripped,
Cobrau seats fitted & sparco racing harnesses

Carbon fiber boot divider fitted


Carbon fiber bonnet & Bootlid fitted along with Carbon fiber splitters


Spec as it stands:

Greddy Emange,
HKS boost controller,
HKS aditional injector controller,
350cc injectors,
Par Forged I beam Conrods
CP Pistons custom pistons
Piston ring's
Gudgon pin's
ARP head stud's
5Zigen Pro Racer Spec A Exhaust ,
De-Cat Pipe,
Custom 3-1 manifolds.
HKS Filter,
VF35 turbo,
HKS Front mount intercooler,
Vernier Camgears
D2 topmounts
D2 coilovers
Evo X Mivec turbo rocker cover
Carbon fiber front Upper Strut Brace
Carbon giber rear Upper Strut Brace
GReddy 3 puck paddle clutch,
330mm Twin Disks front,
3G rear pads
Alcon 6 pot callipers
Yellow stuff pads
Cs Short Shifter
Stainless Steel Dial Rings
Facelift Bozz Front Bumper
Pro Shop Iida Side Skirts
Pro Shop Iida Rear Valance
Carbon Kevlar Bonnet,
Carbon Kevlar Bootlid,
Carbon fiber Boot devider,
Carbon fiber splitter,
Custom Carbon fiber bellypan
OZ Cronos 17" white alloys,
HID's Low Beam,
HID's High Beam,
Toad AI606 Cat 1 Alarm & Immobilisor
Rear fog light convertion
Cobrau Bucket seats
Sparco racing harness's.

[adamvortex]

nice pics dan, my god its a monster in the making not so much a cuddly panda!

[pezza]

Just seen this thread too.. yep more of a wild animal... Hows this project coming along?