Sorry to bring this up, Stu may you remember where you get the REAR bolts from?? VR4 bolts not fit (different thread pitch) and im sure that bolts must be a special strength, may anybody know mitsi part nr ??
ta
Sorry to bring this up, Stu may you remember where you get the REAR bolts from?? VR4 bolts not fit (different thread pitch) and im sure that bolts must be a special strength, may anybody know mitsi part nr ??
ta
His FL Legnum VR4 running 238.8 ATW HP and 500Nm @1.05 bar on LPG
Hers PFL Legnum VR4 COTY see here for full story
Looking for AMSoil? click here
living in north west?
would you like to meet with other VR4 fanatics?
click here
My recent and ex Mitsubishi's
I dont have ASA on this laptop(reminder to myself to install it), but from browsing Amayama.com it looks like MR370730 - BOLT,RR BRAKE 10X30. You will need 4.
The vr4 bolts are the same thread pitch(M10), but are 16.5mm long, so are too short.
Oh and you might need to cut the brembo bolts down too...
Ill have a hunt when Im home tonight with ASA, but from my quick look it looks like the evo5/6/7/8/9 all use the same bolt on the rear brembo's..
Maybe yours have been retaped?
Last edited by adaxo; 28-05-2012 at 09:57 AM.
No worries Adam.
evo and vr4 do not share the same thread pitch on the bolts at all, front or rear.
best to use the original evo bolts, and shorten the rear ones down,
or if you dont have the evo bolts, get Grade 8.8 or better.
Guess I'll have to do mine soon, these put mine to shame
Last edited by Colin Wiltshire; 28-05-2012 at 06:09 PM. Reason: bad English
Bloody good job
Hi
Does anyone know what minimum rim profile requested to use when the brembo conversion is done? is it okay to use my existing 17x7 off set 40 rim + tyre 215/50 without rubbing the flare fender on FL vr4? just curious when my existing wheel used, is it will looked alike they getting off the body/fender? coz i dont want to, i want it stayed inside the fender. any advice will be highly appreciated
Its not all about size of the alloy, its their design. Im doubting that your alloys will fit over Brembo. Make sure you got an wheels design for evo 5 onward and you will be fine. Some cant fit 18' alloys over Brembos due to design of spokes but in the same car evo alloys 17' fits ok.
October 2023 fleet status: 100% operational
| Legnum VR-4S | Fiat Panda 100HP !! | a blue one! | Avensis T-180 | VR-4 parts van! |
Why not become a full member of CVR4 and enjoy the additional benefits membership brings?! Information here.
are the discs standard vr4 size or do you have to put the evo ones on? looks good by the way
no the disks are bigger at 320mm, standard VR4 are 294mm on the fronts, i think.
yes evo fit disks are the correct ones
Bye for Now!