Rear suspension arm

[adaxo]

I think, the best way is to take this off the car an then see what is what, anybody got mentioned above by Dave procedures for check this properly ??

[Nick Mann]

I have had an inner joint go on these arms before, but I could feel clonking when wobbling the wheel at 3 and 9. And I wouldn't have said the movement was as much as 5mm. Once the arm was off (Not too difficult - ball joint at outer and bolt at inner) the play on the inner joint was very obvious. The inner bolt controls the toe angle of the rear wheel, so mark it up before removing and you can put it back the same way. I'd still be tempted to have the toe checked after though!

[adaxo]

those tracking arms are cheaper if u get them from mitsi garage - 65quid each, and according to spec they aint same as n/a v6

Just order a pair, yes you right 65 quid each + VAT, collection and fitting tomorrow (hope)

[stu]

Fitted mine on Saturday, only takes about 10 minutes a side.

[ianturbo]

I nearly bought some of these arms other year off Dave but as he has put in his post they do move when pulled front to back !
ian

[Davezj]

Here is an ebay link to the correct part number even if it is from USA and list for an eclipse.

http://www.ebay.co.uk/itm/MITSUBISHI...MAAOSwIgNXpe1q

correct numbers are:-

rear right MR325256

rear left MR325255

Here is a listing on Viamoto.com
http://www.viamoto.co.uk/proddetail....alant+VR4+EC5A
£86 each