Hi.
I have bought a tactrix openport cable and I have various versions of Evoscan, (2.1 2.5 2.6 2.7 &2.9), I just got the cable this week, and can't actuate anything or read fault codes.
I have tried various settings on evoscan, (mutII, OBDII, etc), and tried different versions of evoscan to try and connect, but no joy as yet!.
Can someone, tell me what version of evoscan I should be using with an openport 2.0 cable, and what settings to set evoscan to to get them working please.
When I connect the cable to the OBDII port in the car, I dont get any flashing lights on the dash!.
I have noticed that there are small led's in the OBDII connector part of the 2.o Cable, (clear plastic), and they seem to be steadily cycling through Blue, Green, Red (from left to right constantly.
Main thing I would like to know is:, Have I bought a duff cable?.
Do I require different or additional software (ecuflash?, ECUEDIT,) to get them working?, I only have evoscan at the moment.
Any info or pointer would be most appreciated,
Cable has Tactrix inc PoenPort 2.0 Rev E sticker on it.