Still getting AYC error code 82 - help!

[Jesus-Ninja]

Grrrrr!!!

New pump went on yesterday, which made good pressure on a test bed, and ran up until the stock switch opened. All in, primed, and bled, but still get the AYC light on. Anything else I could try? I'm 99% sure the pump is good.

[Jesus-Ninja]

Relay! Gotta be. Pump doesn't prime when turning on the ignition. Found my relay, left unbolted from the wing, upside down, under the big hole I cut for my cold air inlet. 12v across the solenoid and the switch doesn't close.

Where can I get one from?

[c0xxy]

its the same as an fuel pressure relay in a supra, that's where my replacement was from, so can't be too special.
im guessing you're in a hurry for it? could bung ya one in the post tomorrow evening if you don't find one sooner.
cheers
ash

[Jesus-Ninja]

Yeah, needed it ASAP. It must be fairly beefy, as the system is fused at 60A. I used 2 x 40A relays in parallel 2.49 each from maplins

Sent from my GT-I9100 using Tapatalk 2

[c0xxy]

glad ya sorted it, bet that's saved ya few bob too

[Jesus-Ninja]

Yeah, needed it ASAP. It must be fairly beefy, as the system is fused at 60A. I used 2 x 40A relays in parallel 2.49 each from maplins

Sent from my GT-I9100 using Tapatalk 2

Well, they lasted well enough, but both relays have died. I suspect that as they are in reality never going to close at exactly the same time, each relay will be subjected to spikes of over 40A. Hey ho. Glad that the light coming on again was easily identified as duff relays this time. Obviously once one had gone, the other was doing all the work and was never going to last either.

Did a proper job this time - Landrover 60A relay - http://www.ebay.co.uk/itm/1608287158...84.m1439.l2649