yes i am...still standard airbox.....what clearance would you like me to measure for you?
[SIGPIC][/SIGPIC]
Do you think you could take a photo of the standard pipe and airbox in place? Particularly how close together they are? You will need to take off the plastic pipe that comes off the throttle body and the flexi pipe thats joined to that to get a clear view. While its off try measuring across the standard pipe, 65mm wide near where it joins at the top. If you imagine the standard pipe being 65mm wide all the way down instead of that weird shape it should give you a good idea if it would fit.
Daily driver / circuit car / drag car / show car / weekend cruiser / project car
@veegeeta I can go ahead with just yours if you like, I know you've been waiting a while! Not sure how long you could be waiting otherwise.
What the plus side off doing pipe cause me an a mate was saying how the skylines run two pipes to the turbos but i no there a AFM on the legnum or could you run the front turbo on a new pipe with a airfilter ??
790x290x80 intercooler
De-Cat/straight through center pipe 2.5"-3"
HKS lowering springs R:35mm F:25mm
oil presser/oil temp/boost gauges
17" GT RS alloys
Well, yes. Physically you could. But the maf would only be seeing half of the air going into the engine, which means the ecu would only know about half the air, and only inject half the fuel. So you'd be running very lean and likely cause expensive damage to the engine.
I guess you could retune the ecu to double the amount of fuel per load reading or something, but its not really an ideal solution.
Fairly close to ideal and what is commonly referred to as a MAF bypass.
The main issue is that you then need to balance the air flow behind the MAF / in front of the turbos. This is so that the air flow through the MAF is always proportional to the amount bypassed (which is how the MAF works in the first place). Without this, the turbo attached to the bypass could do something odd (say slightly sticky wastegate or some such) and result in far more air bypassing the MAF and causing a dangerously lean condition.
@veegeeta your shiny new pipe ready to be sent.
05092012051.jpg
verry nice mate can't wait to see it turn up
Oh my just seen this and would love one too if thats even possible!
@roryfromnz (or anyone else) if you're still keen on one of those pipes Im going to the fabricator this Thursday.
I'm keen how much?
I'm also interested.
Yes please how much are you looking?