RPM wire from ecu

[NLduffyNL]

I am installing my apexi avc-r at this very moment.
Is there someone that can tell me wich wire from the ECU is the RPM signal?
I looked at the diagrams but there it says connector C the 10th. But at no galant/legnum is there a wire in that connector.
Where should i connect it to then?

I have allready connected one to the speed signal on connector D 16th.

I hope someone reads this and could help me today so i can finish it

[NLduffyNL]

Or should that be the same? (those wires are both white-green)
so i wire them both on the speed signal?

[GalantOnly]

12-pin connector, bottom row, second from left

[NLduffyNL]

the ecu diagram say's that is the ignition failure sensor?

[GalantOnly]

Exactly
The wire from ECU splits to ignition failure sensor, proof connector and tacho

[NLduffyNL]

Ok We'll let's go connect! that would be the last one
Thank you