Hello,
I will explain my problem in English and French because my English is too basic and google translate will be incomprehensible, if a charitable soul and bilingual passes by and can expose this problem in proper English I am grateful!
My vehicle:
Legnum VR4 Type S Facelift 2000 68000 miles auto box
2 days after get stereo (including a station 2 din) in a garage I had the following problem:
- By moving the shift lever to D the vehicle is not moving, the more light the lamp D and R are on the counter and the "beep beep" reverse is heard.
- In passing mode tiptronic nothing changes the problem is the same and the car not moving
- In R mode everything is fine and the car back
Positive, playing with the gear lever for 10 minutes usually, by passing from N to D speed snaps and so good the car ahead and five reports work perfectly despite the lights R & D and beep reverse are always present.
BUT do not touch the lever while driving because if I should start over and replay the shifter until the first gear snaps.
No mechanical noise, color and perfect oil and I think more an electronic problem level.
So I removed the base of the gear lever and I discovered a wire broken leg.
Metal tab with a small "roll" at the end which was used as a guide and placed in four notches depending on the position of the lever P / R / N / D but I do not see any switch connected to this leg.
I will very soon pictures to help explain my problem. Have you ever had such a problem? Any help is welcome!
thank you
__________________________________________________ __________________________________________________ _____________________________________
Bonjour,
Je vais expliquer mon problème en français car mon anglais est trop basique et google translate sera incompréhensible, si une âme charitable et bilingue passe par lÃ* et peut exposer le problème suivant dans un anglais correct je lui serai reconnaissant!
Mon véhicule:
Legnum VR4 type S Facelift année 2000 68000 miles boîte auto
2 jours après avoir fait monter une sono complète (notamment un poste 2 din) dans un garage j'ai eu le problème suivant:
- En positionnant le levier de vitesse sur D le véhicule n'avance pas, de plus le voyant D ainsi que le voyant R du compteur sont allumés ainsi que le "bip bip" de marche arrière se fait entendre.
- En passant en mode tiptronic rien ne change le problème est le même et la voiture n'vance pas
- En mode R tout va bien et la voiture recule
Point positif, en jouant avec le levier de vitesse pendant 10 min généralement, en le passant de N Ã* D la vitesse s'enclenche et lÃ* tout va bien la voiture avance et les 5 rapports fonctionnent parfaitement malgré que les voyants R et D ainsi que le bip de marche arrière soient toujours présent.
MAIS interdiction de toucher au levier pendant un trajet car sinon je devrais recommencer l'opération et rejouer avec le levier de vitesse jusqu'Ã* ce que la 1ère s'enclenche.
Aucun bruit mécanique, couleur et niveau d'huile parfait et je pense plus Ã* un problème electronique.
J'ai donc démonté la base du levier de vitesse et j'y ai découvert une patte métallique cassée.
Patte métallique avec un petit "rouleau" au bout qui devait servir de guide et se placée dans 4 crans en fonction de la position du levier P/R/N/D mais je ne vois aucun contacteur relié Ã* cette patte.
Je ferai des photos très prochainement afin de faciliter l'explication de mon problème. Avez vous déja eu un tel problème? Toute aide est la bienvenue!
Merci