Ok guys i am asking what difference the setup peramiter make when setting up a shootout_44 runs.
i am presuming these are dyno technitions setup peramiter for the day, and i am also making an assumption what they mean.
these perameters are in a table on the dyno print out or at the bottom of the print out.
BP = 991.4 (Barometric pressure)
RH = 73 (Relative Humidity %)
AT = 9 (Ambiant Temp deg C)
IT = 13 (possible Inlet Temp deg C, not sure?)
RR = 100 (Ramp Rate)
TN = 3.243 (not sure?)
20131109 = 105023 (09 11 2013 10.50:23 Date and time stamp for the run)
CK = 811 (not sure?)
CF = SHOOT_44 (type of dyno test shoot_44 is a basic power run)
Tyre Pres = N/A (tyre pressure)
Gear = N/A (gear)
What effect do these perameter have on the dyno result and can they push the power figure up and down if they are not set correctly.
i am asking this as a possible discussion point for the vast difference in power figures (for seemingly the same mods) that are achieved in the UK and in our counter parts south of the equator.
i know this has been discussed before but i have been rereading some theads and i have noticed some differences in the dyno result sheets but i don't know if these perameter will make a difference.
What do you think anyone?
@Eurospec @Nick Mann @Kenneth @adaxo @Gowf @fassi1 @foxdie