I have taken on a bit of a mission in converting a 2001 galant to manual out of a 97 legnum, had the old engine running with my fl auto ecu,however used another engine and haven't had that running yet, I have used all the engine harness and dash loom, speedo etc out of the legnum. It will crank over but won't start as I have no fuel pump running on cranking only way it will go is if I hard wire it to a battery but even then it won't fire, it has spark I have checked several times, it has an safc connected and Rev speed meter which did have power originally but stopped working at some point, the red wire from the ecu is not putting out any power now which the safc is connected to, found some soldered connections that more than likely touched at some point so I'm thinking I have fried the ecu? I have checked the engine fuses and in car fuses with no joy, also without key on as soon as the battery is connected the fan runs constantly and the climate control turns on this is what happened when the car had no ecu and the battery connected which has got me wondering if the ecu is now no good, any info appreciated guys, also who do I get in touch with to renew my membership I have been trying for ages with no luck, cheers