My Legnum came from Japan with a nicer rear wiper arm than stock. I am 99% sure it is from a Mazda 6 - it is a 14" wiper with a moulded arm that looks much more modern than the stock item.
s-l300.jpg
My Legnum came from Japan with a nicer rear wiper arm than stock. I am 99% sure it is from a Mazda 6 - it is a 14" wiper with a moulded arm that looks much more modern than the stock item.
s-l300.jpg
I have a similar one, but fitted myself, it's from a Colt I believe (mitsi part)
@adaxo
adam has a mazda 6 so he will be able to confirm if it is the same.
Nick was your post a statement of parts compatibility or or are you look to replace it.
Bye for Now!
Mine has been replaced before I bought it but the wiper needs replacing. The fitment is not the same but Vicky has a Mazda 3 so the fitment was easy to check. The size is different though on the Mazda 3. Googling shows the Mazda 6 has the right length wiper so I have put 2 and 2 together. Adam can hopefully confirm if I have come up with 4!
I got one of ebay a while back, I think it was for a mitsubishi something!,, image attached (hopefully lol!)
https://www.clubvr4.com/forum/garage...nt.php?id=3765
I will try and remember what it was from!
Updating Soon!! 1998 Legnum VR4, fully serviced every 4500 miles. Fully Amsoil'd. Falken 453's, EVO 8 FQ320 rear diff.
I removed the whole wiper and motor then just put a rubber in the hole.
I believe common thing is to put a Mitsi Outlander wiper arm on. It's rather short and with wiper blade it will hardly be reaching the area of the high level brake light. I have a wiper arm from a Colt plus which also has a longer wiper to clean the same area as the factory wiper arm did.
Both wiper arms are moulded plastic type with clip-on wiper blade. How long is the wiper blade you need? Outlander is 330mm IIRC....
the one and only...Pearl White Legnum 25 ST-R...registered in Germany - now featuring a 6A13TT engine (unless you know otherwise)
The one on my car is 14" - 350mm.