Hi guys, you've brought something to light for me in one of your other posts with engine and under bonnet heat concerns ...
I've been reading all your posts about cooling fans and duty cycles Is this a common concern/issue i need to be worried about.
With all my mods and under bonnet heat problems i had last time. I've even bought a 36mm hole cutter and some rubber edging to make 5-6 holes in the bonnet along rear top edge (bulkhead area) just to get the heat out!
I burnt and shrivelled up some cable tidy along the top of the bulkhead and all through it didnt damage the wires too much it raised my concerns.
I've even tried bonnet hinge spacers to raise the bonnet up from the bulk seal but because of the bonnet and wing shape when opening and closing this is not possible to do.
Does anyone have some ideas?
Dave O
Sent from my SM-G930F using Tapatalk