After the rubber seals that reside between the headlight and front wing.
Preferably both, but definitely the nearside one!
20191110_160225.jpg
20191114_231012.jpg
After the rubber seals that reside between the headlight and front wing.
Preferably both, but definitely the nearside one!
20191110_160225.jpg
20191114_231012.jpg
October 2023 fleet status: 100% operational
| Legnum VR-4S | Fiat Panda 100HP !! | a blue one! | Avensis T-180 | VR-4 parts van! |
Why not become a full member of CVR4 and enjoy the additional benefits membership brings?! Information here.
I'm pretty sure only EU spec head lamp have this seal not seen them on jdm lights
His FL Legnum VR4 running 238.8 ATW HP and 500Nm @1.05 bar on LPG
Hers PFL Legnum VR4 COTY see here for full story
Looking for AMSoil? click here
living in north west?
would you like to meet with other VR4 fanatics?
click here
My recent and ex Mitsubishi's
I have this exact problem as well, the offside seal works loose and flails around in the wind once every month or two. I’m half tempted to daub a spot of glue/double sided tape to hold it in place if no one does a replacement.
I bought dense foam 2cm adhesive back strip and attached it ebay. been on for about 2 years no probs
Updating Soon!! 1998 Legnum VR4, fully serviced every 4500 miles. Fully Amsoil'd. Falken 453's, EVO 8 FQ320 rear diff.
Part numbers MR957479 (LH) and MR957480 (RH).
Headlamp seal.png
I still need to check the mean stealership!
OMG 17.60 for one piece of rubber, sounds like joke to me
Screenshot_20191116_170055_com.android.chrome.jpg
Actually I have one but driver side
IMG_20191116_170530.jpg