1996 Legnum vr4 PFL

Hi folks, I'm having a lot of issues in removing the outer cv joint from the hub.
I've pulled the split pin, undone the castle nut and I'm assuming that the joint should just slide out the back of the hub but it won't budge at all, I've used 3 legged pullers, club hammers etc

I've doused it in wd40 for days, im reluctant to apply heat due to the abs sensor still in the hub - I also don't want to remove that as I'm told they often break during removal and are difficult to source and expensive to replace.

All of my control arms are free to come out and have come out recently so no issues there

Is there anything I'm missing in the procedure here?

Sent from my SM-G973F using Tapatalk