Does the above mitsi part numbers for curved front arms , not the straight lateral ones fit the vr4 please?
I've tried but nothing confirming
If someone knows that would be great thanks.........
Does the above mitsi part numbers for curved front arms , not the straight lateral ones fit the vr4 please?
I've tried but nothing confirming
If someone knows that would be great thanks.........
What you asking?
If they are right?
Found this after searching on cvr4
Lateral arm LH: MB912509, RH: MB912510
Compression (curved arm) LH: MB912511 , RH: MB912512
http://www.clubvr4.com/forum/showthr...light=MB912512
SUPPORT CLUBVR-4 TODAY!
Please do not PM Moderators and Committee Directly, for quicker response times please follow this guide
HOW TO: Contact Committee or Moderators
My Articles: Fog Light in Rear Cluster - Changing AYC Switch - Changing Drive Shaft - Changing Front suspension
My Projects: Installing Uprated Clutch - making Gauge Pods (Tri-pod)
Club Related: HOW TO Guides - HOW TO: Contact Committee or Moderators
RIP: Type-S - 1998 R - Trigger Mauve - Mauve History | First VR4 - Second VR4 - Third VR4
Get your own fuel sig in the Garage (Members Only) - Visit my Garage ........What Is Geocaching?
Thanks Barry, I did look but never came across that thread (or I just missed it)
I need to know if those curved arm numbers are for or will fit the vr4?
I think the v6 ones are the same but not to sure? If it comes to it I'll phone mitsi
from Camskill site:
PRODUCT MODEL
(EC5A EC5W Legnum/Galant VR4)
PRODUCT OPTIONS
LH Curved Front Arm,
RH Curved Front Arm
Description
Front curved arm. See pic for location.
Quantity
ONE
Notes 1
These are now supplied as OE arms.
We do not supply aftermarket ones as we've had too much trouble with failures.
Manufacturers Part Numbers for REF ONLY
LH= MR296293
RH= MR296292
http://www.camskill.co.uk/m22b0s1403...num_Galant_VR4
Updating Soon!! 1998 Legnum VR4, fully serviced every 4500 miles. Fully Amsoil'd. Falken 453's, EVO 8 FQ320 rear diff.
ASA says louis is correct for a my car anyway (98 VR4), and the same for a 2001 FL i have the chassis number for.
steve give me the chassis number of the n/a V6 and i can get you the correct curved arm number for you.
Bye for Now!
They are the same in v6 n/a Galants.
IIRC, also been used in some Hyundai vehicle, but can't tell which one. Other day I've purchased Hyundai arms for less than 50% Mitsi price with the same quality built (Glenn and psbarham had seen them). And factory numbers started with MBxxxxxx.
Ex: Galant VR4
Running 268 HP ATW and 443 Nm torque at 0.9 bar
Now: Lancer Evolution 8 FQ-300
Running 325 HP ATW and 510 Nm torque at 1.6 bar
That sounds like a good option so MB numbers above are correct for the VR4.
It just so happens that I am in need of a curved arm or two.
So this part number for the curved arm is a confirmed fit? Same as MR296292, and I guess Mr296290?
I'm trying to figure out if this TRW part would fit.
https://aeromotors.ee/kataloog/artic...286/jtc726-trw
use this website to check part numbers against your specific VIN number.
https://mitsubishi.epc-data.com/