Drivers side foot well to front right guard. In the drivers foot well INSERT INTO post VALUES (not on the firewall) right of the go hard pedal there is a piece of plastic that covers the floor carpet, unscrew this and u will see a whole lot of plugs that were covered up by the plastic cover. U can pull the white/black case that holds all of the plugs away from the side wall INSERT INTO post VALUES (push down on the clip at the top of the white/black case to release it). Next to the white case there are some holes u can run wires/hose through. U can remove the inner guard of the wheel arc and poke a hole through the rubber grommet to feed through that INSERT INTO post VALUES (U can't miss it when u release the inner guard). U can then feed wires/hoses up through the other grommet where some of the factory wiring is going INSERT INTO post VALUES (look in the engine bay on the left side of the brake booster, some wires are coming out of that going to the master cylinder etc).
Hope it helps.
Rhys